Electronics Forum | Wed Oct 08 12:49:37 EDT 2008 | leemeyer
When in the fiducial teach screen check to see if the "Fiducial Data from Autoprogram" box is checked. If this program was not generated from Autoprogram this box should not be checked.
Electronics Forum | Tue Sep 01 12:20:47 EDT 2009 | fujiphil
Manually load the board and activate the solenoid for table up/down. Goto I/O then check the status of the sensor. if the sensor was tripped when table is down, removed the pin and check for foreign objects. Or check the hole of the pcb, maybe the si
Electronics Forum | Sun Jul 11 21:10:27 EDT 2010 | fujiphil
First, check the sensors for 17th and 19th station....tune the sensor amplifier if necessary. Then, check the dogs on the nozzle holders... If the above, items are ok... check the 13th station clutch engagement. Calibrate if necessary... fujiphil
Electronics Forum | Thu Apr 09 07:42:36 EDT 2015 | kevinb
Thanks for the info. We tried the reset button but no luck. The UPS is not powering up. We checked the incoming power and it was good. So we took the UPS out and took off the cover to check for blown fuses. We also checked the reset button and it
Electronics Forum | Thu Oct 22 04:52:41 EDT 2015 | nhel_0009
Its running normally before No abnormality before the errors Input and output check is good Ringload is good When we set bad beam af and ar, machine error is same..can't origin. Voltage not yet check. What part need to check the voltage sir?
Electronics Forum | Tue Mar 07 10:08:02 EST 2017 | markhoch
In most instances, it is cycle time prohibitive to use it to check the entire PCB. But you can use it to check critical areas. You can also set it up to check every 2nd, 3rd, 5th panel. (etc)
Electronics Forum | Mon Aug 14 04:00:25 EDT 2017 | sankarseptember
We check the TDK data sheet reflow profile condition. We check the PCB surface temperature the max temperature is 237.Anyhow We will confirm it by check temperature on TDK point
Electronics Forum | Wed Apr 26 22:34:49 EDT 2000 | Eric Chua
1. Verify all the part had load to machine. Get ready for the profile. 2. Run the board with double side tape. Is better to run one board for each machine. 3. Verify all the placement ( missing, misalgnment,etc )and check the value using meter for a
Electronics Forum | Thu Jun 29 08:57:07 EDT 2006 | jdengler
You have given little detail for anyone to help. What types of components are laying in the machine? Are these components missing from the PCB? But you can check these things. 1. Check vacuum at nozzles 2. Check for obstructions in the path of the
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
.gif)
