Electronics Forum | Wed Aug 18 21:10:23 EDT 1999 | se
| | | Hi, | | | I'd like to ask some tips about the merits and shortcomings o | | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | | application? | | | The board
Electronics Forum | Fri Jul 21 09:23:05 EDT 2017 | sumote
I am not going to give you any names of equipment manufacturers as I believe most people tend to recommend only what they are familiar with. I have my favorites as, likely, most everyone else does as well. What I will tell you is equally important.
Electronics Forum | Mon Feb 26 16:26:00 EST 2001 | jax
I have not placed these parts in a while but when I did Universal was the machine that did it. We were able to place these parts using a 1mil flat( upward looking camera) inspecting all columns. The problem is a 100% column recognition is not possibl
Electronics Forum | Thu Aug 02 06:39:21 EDT 2001 | Binns
Jay In reference to your original question ( not including my previous off-hand remark ) I have not heard that multitronics will be the only machine from the new tyco company, but if it is true i think that would be the single most foolish thing they
Electronics Forum | Wed Aug 18 15:20:25 EDT 1999 | John Thorup
| Hi, | I'd like to ask some tips about the merits and shortcomings o | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | application? | The boards contain no BGA and
Electronics Forum | Thu Aug 01 12:55:41 EDT 2002 | johnw
we run the paste in both air and n2 depending on customer requirements again it run's fairly well in both. Some people say it's better sme say it doesn't make a bit of difference, I'm somewhere in between at the moment. I definately think there's imp
Electronics Forum | Thu Aug 24 15:30:33 EDT 2000 | Steve Thomas
On your last point, Wolfgang, I agree big time. Not that I disagee with the rest, but it's pretty much all been said. The layout of the forum is showy, which is OK by me as long as they've got the hardware to support it. Unfortunately they don't, a
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Fri Jul 16 13:41:24 EDT 2004 | Frank
I agree with everybody here. There are plenty of better options than what you have proposed. Without knowing your equipment brand, or what type of offline software you have, if any, I have a few suggestions. 1) If you don't have any offline softwa
Electronics Forum | Thu Dec 16 15:00:20 EST 2004 | glaucon
Simple differences. Both processes require a very similar machine platform, controlled motion, vision fiducial recognition and alignment of a substrate (PCB or hybrid ceramic) to the "image", the image being either a stencil (hence stencil printing)