Electronics Forum | Thu May 30 20:09:58 EDT 2002 | myu
Thank you very much, Dave and Steve. I got paste and wire from Indium and Qualitek. Are there anybody with high-temperature reflow experience (330 degree C)? Is it OK to use Regular Convection Reflow Oven (We have a Conceptronic HVC 70, 5 zones) ?
Electronics Forum | Wed Jun 21 16:04:07 EDT 2006 | bman
"Another question, is the facility with 200A @ 208V able to operate this assembly line properly?" That could be a problem, big ovens pull a lot of juice. Our 7 zone Conceptronic HVN-102 runs on 480 Volts and is on a 160 amp breaker, for example. Y
Electronics Forum | Tue Dec 11 16:55:11 EST 2007 | dman97
Hi, I am using a 7 zone Conceptronics oven and Indium 3.1 lead free clean paste. Our profile is as follows, 130 140 150 180 200 240 260 with a belt speed of 36 inches per minute. I dont know if that will help you out though...
Electronics Forum | Mon Jan 07 10:56:40 EST 2002 | bcaler
Who did you buy this oven from? What is the model number? I bought a used Conceptronic oven last year...It ran great when I saw the demo. But, when is arrived at our factory we found someone pulled out some relays and it wouldn't heat. Hope you h
Electronics Forum | Thu Feb 26 10:38:00 EST 2015 | swag
We don't have parts around anymore but I can offer a tip that might help. Our conceptronic is gone but the major issue we had with it was bearings going out on blowers. We rebuilt them in-house. Found a high temp. bearing through a bearing supplie
Electronics Forum | Sat Oct 30 12:17:25 EDT 2004 | dorklover664
From an operators stand point there really is no difference. I think what I work with now is a 7 zone and I have worked with 8 and 5 zone BTU ovens. The only difference I can really tell is on the 8 zone oven we had less bridging at the end. If you r
Electronics Forum | Tue Sep 16 10:15:48 EDT 2008 | mw_fl
Would appreciate any input you might have in our search for an SMT line. We are an OEM done our through in house but outsourced our SMT production. We have a couple of new products that are going to be higher volume so we have decided to look into ad
Electronics Forum | Thu Oct 16 10:29:42 EDT 2003 | james
Did you ever change the passwords on the oven or were they defaults and you dont remember them? Because for level 1 is the number 1 for 2 it is 2 and for level 3 it is 3. Hope this helps.
Electronics Forum | Mon Oct 17 10:39:06 EDT 2005 | russ
Why are you soured on Vitronics? I like them the best of all I've used including BTU, Speedline, conceptronics, Heller, etc...
Electronics Forum | Mon Feb 28 10:19:16 EST 2005 | jbrower
Hi James, Sure, I'd be happy to share my base line. zone1 140 zone2 170 zone3 200 zone4 230 zone5 270 belt speed 19"/min This is the base line that I started with. I hope that this helps. Best regards, Jay