Electronics Forum | Tue Sep 11 22:03:47 EDT 2007 | duyhoang
Hi all, Please show me what range of min and max component can be handled of these machines: _ FUJI IP2 _FUJI CP3-4000 Thanks,
Electronics Forum | Tue Nov 06 09:10:02 EST 2007 | ralphspm
What would be the best software packages available to produce assembly programs from basic gerber data?I'm using FUJI CP3 & IP1 M/C's with fujiflexa software.
Electronics Forum | Thu Dec 02 07:48:58 EST 2010 | jdengler
Check with IBE (800) 353-6942. They had a LCD replacement kit they were selling. Jerry
Electronics Forum | Sat Apr 13 16:34:00 EDT 2013 | jimmyboz
Most likely battery back up card, might be 1931, 1932,ect. It thinks there is a power failure
Electronics Forum | Mon Apr 15 20:44:00 EDT 2013 | dman97
So I swapped the memory card out and it seems to be a bit better. It doesn't kill the 24v power quite as much anymore. Thanks for the tip. I will monitor this throughout the week.
Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Wed Oct 02 07:43:21 EDT 2013 | aj
could be a faulty motor? you can check the voltage at the connection to the motor when the IO is on.....or swap the motor.
Electronics Forum | Thu Nov 14 17:22:47 EST 2013 | dman97
Yes CP4 with vision type 12 will place these no problem. I am even putting these down on an old CP3 with no problems.
Electronics Forum | Mon Nov 10 23:14:25 EST 2014 | peteb
Do you have the correct keyboard? Are all of the keys accurate for MCS?
Electronics Forum | Tue Nov 11 13:25:17 EST 2014 | jimmyboz
I do not recall that "TEACH" ever worked. Even if it did, there is no way to save this data to the MCS. After you see that a fiducial cannot be found, change Xa-Ya in the program at the MCS to find it, and of course, re-transmit. Good Luck