Electronics Forum | Fri Apr 14 13:36:44 EDT 2006 | cyber_wolf
Dax, More than likely your moveable rail is slipping on the X-Y table. Make sure there is no oil where the breaks grab the table. Sometime the breaks wear out and need replaced. The contact surface on the break lever is only a couple of thou.. We hav
Electronics Forum | Mon Jul 10 16:37:10 EDT 2006 | mac
Hi All, Lately we have been getting a humming noise which seems to be coming from one of the D-axis motors on the CP4. If it happens the Op. hits the e-stop and resets the machine which clears the noise and machine runs fine. Obviously there is a
Electronics Forum | Fri Feb 01 05:42:21 EST 2008 | aj
Hi all, Is anyone out there placing 0402 with a CP4? Not sure how reliable it would be and also how do work around the nozzle setup ? we currently have 2.5mm ,1.3mm & 1.0mm so do you remove say 6 x 2.5mm and put in 0.7mm. Any replies appreciated.
Electronics Forum | Fri Feb 01 09:34:54 EST 2008 | jdengler
In the PD for 0603 I have a min size of 0.7mm and a max size of 1.0mm and the CP4 size at 0.0mm. This way when you have 1.0mm nozzles in the machine it will use that and when you change them to 0.7mm it will use that. Both sizes work OK. -Jerry
Electronics Forum | Fri Feb 01 12:23:46 EST 2008 | mulder0990
If you do not want to buy a new feeder there should only be 2-3 parts you need to change on your CP-4 feeder to make it an 0802. the only difference between the 0804 and the 0802 are the Link, the sprocket, and the stopper. Everything else is exact
Electronics Forum | Sat Sep 08 23:36:14 EDT 2012 | mtech88
Can anyone help me out this Fuji CP4 problem? I just move my machine to a new place, The feeding sensor error keep on poping up. but the mahine work on manual mode. When we switch to auto mode, it just to pick up the part and the machine stop on t
Electronics Forum | Thu Jul 31 08:46:16 EDT 2014 | kurtiss
We currently have a CP4-3 that is having the nozzle change alarm on different holders. there was a part found in the machine and I do not know if it is part of the machine or not, see picture. Any advice on what this part is or how to resolve this is
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Sat Aug 22 00:23:10 EDT 1998 | Arul Vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as Fuji CP4-3. In both the m
Electronics Forum | Sat Aug 22 00:11:49 EDT 1998 | Arul vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as FUji CP4-3. In both the mac