Electronics Forum | Thu Mar 18 18:52:29 EDT 2010 | edwaterfall01
There is a retrofit kit to take care of the head cable problem that you mention. The s/n with 7P in it represents what is called the 7 Plus level of the head. There was one more level after that (09) for the GSM. The better heads mentioned in the
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Wed Jul 26 18:23:47 EDT 2000 | Gary
I have been following forum discussions here and eslewhere, attended technical sessions at APEX and have been experimenting with the paste-in-hole process on some of our new product. I have run into one problem I have never seen mentioned, that is a
Electronics Forum | Mon May 15 13:55:00 EDT 2000 | Aldo
We are in the process of researching manual or low cost automatic Tape and Reel equipment. I have heard about V-tek and Systemation. I would appreciate if someone can tell me any problems or virtues of theses two brands that have been experienced. Al
Electronics Forum | Fri Mar 24 15:20:27 EST 2000 | Chris McDonald
I have recently purchased a Tape and reel machine from V-Tech. We are using Presure Sensitive tape and we are not geting good results. Anything bigger that a SOIC14/16 gives us trouble. The cover tape will pull off on the feeder and we will lose part
Electronics Forum | Thu Jun 07 15:37:32 EDT 2001 | Claude_Couture
Kerryn, It's the first time I hear someone who needs an automated inspection machine to check the cleanliness of stencils. Why not improve on the cleaning method itself. I use ultrasonic batch cleaner. It takes 3 minutes to clean a stencil, 2 minutes
Electronics Forum | Wed Nov 06 05:13:01 EST 2002 | Dreamsniper
Crystalline flux if it is really clear should not be a problem. We were using Amtech paste before and we have the same results. Sometimes we mistakenly see it as a dry joint because of the reflections from the lighting of our Metcal inspection system
Electronics Forum | Wed Sep 24 08:34:57 EDT 2003 | stefwitt
Even when you run a board several times, the machine may not make the same travel path every time. This in itself does not create a problem, but the vacuum on the nozzles could be different, dependent on the configuration of components on the heads.
Electronics Forum | Wed Feb 09 12:28:58 EST 2005 | Valerie
We have been pretty successful with screen printing glue, however the smallest component we now glue is a 0805. We had many problems using our Gemini II to put down glue dots for a 0603, so we altered the pads to do double-side reflow. As our own int
Electronics Forum | Thu Jul 14 11:52:16 EDT 2005 | davef
Sure you can use SPC charting on the wave setup parameters to warn of impending problems. Examples of useful points of analysis are: * Dwell * Temperature * Pot analysis Certainly there's a range of other process controls that could be monitored.