Electronics Forum | Wed Jan 16 14:14:19 EST 2019 | mattkehoe
We have an older MPM SPM machine, circa 2001 that is having a hard time reading the PC hard drive. Worked fine until yesterday. We are looking for a software install package for it or, preferably, a PC with the software on it.
Electronics Forum | Wed Aug 18 09:05:52 EDT 2004 | Stefan Witte
With this many hard drive problems, I would search in other directions. You may have a defective power supply or a bus switch on the motherboard. I would dump the entire computer. With Linux you have to be a bit more selective in the components. I wo
Electronics Forum | Wed May 26 17:46:02 EDT 2004 | pjc
Electrovert has hard data on electrical and N2 consumption for the new OmniEXCEL series ovens to compare with preceeding OmniFlo series. Have a look.
Electronics Forum | Fri Jun 24 13:56:05 EDT 2005 | John S
This is a little late, so I hope you've been in contact with E-vert. We've experienced the same thing on our two vectra's. It normally happens right after a bad electrical storm. The shared drive will have to be reprogrammed. E-vert can fax you a
Electronics Forum | Thu Apr 15 23:13:29 EDT 2004 | pyro747
What we are finding that the volts on the Drive motor are dropping when the oven gets hotter. As for the encoder not pick up the drop in speed, I ran the wires for the encoder outside of the oven away from everything, didn't help!!! I swapped PC's
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Wed Feb 21 14:56:09 EST 2007 | chrisgriffin
I just had to replace the hard drive in the SC and the MC. I partitiones the MC drive and installed all operating systems. The machine boots up and gets past "software booting", "conversion of machine data", and then hangs on "initializing machine"
Electronics Forum | Mon Jul 06 11:17:56 EDT 2009 | slthomas
xcopy is probably the cheapest way, although it's a manual operation. We just used a batch (.bat) file called "backup" that ran xcopy on our pcb file directories and dumped the copies to a second hard drive on the same pc. If you can't install seco
Electronics Forum | Fri Feb 16 13:56:15 EST 2024 | redspare1
Acronis is the way to go and the cost is reasonable. https://www.acronis.com/en-us/products/true-image/ You install this on a modern windows PC, make a bootable USB or CD-ROM. Then boot your old computer and save to USB or hard drive. You can also sa
