Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Wed Aug 23 17:43:42 EDT 2023 | calebcsmt
Support bars, so essentially the board is sitting ontop of beams that make a table. Fully supported with no soft spots
Electronics Forum | Thu Aug 11 07:41:55 EDT 2005 | rsmith@z-mar.com
I do recommend dedicated tips and dedicated workstations. Make sure that your tips come in with no lead in the tinning. There is a new, green heat resistant table mat that is being used in the industry to identify lead free areas. If operators see gr
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Tue Dec 05 15:10:55 EST 2000 | Francois Monette
Victor, here are a few more elements of information to answer your question. Both the temperature and relative humidity on the manufacturing floor have a significant impact relative to the rate of diffusion of moisture inside a plastic package and t
Electronics Forum | Sat Apr 20 10:12:16 EDT 2002 | davef
If people use an inert gas, they use nitrogen for mass soldering. Inert gases get progressively more expensive as you move down the periodic table. Many times no-clean flux is less active than other flux types. So, people use an inert gas to lower
Electronics Forum | Wed Nov 29 08:25:28 EST 2006 | aj
Hi, I work mainly with Fujis but have some experience with Panas. If you are seeing components upside down on the board it is feeder related . If you are seeing poor alignment across the board , firstly I would check the xy table for alignment. Mak
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Tue Aug 09 22:03:38 EDT 2005 | davef
Since these are mounting holes, they're probably all the same size. Why not try rubber plugs shaped like golf tees? Try: * Dempsey Industries; 802 N. 4th St, Miamisburg, Ohio 45342; (937)-866-2345; Gary Pascoe * Shercon somewhere in CA * Harman; 36
