Electronics Forum | Thu Jun 23 14:07:14 EDT 2005 | dutch69
Your MPM memory evidently full.When you save file sure that is saved correctly .Always save file during printer work .
Electronics Forum | Thu Jun 23 14:34:17 EDT 2005 | pr
Is it only this 1 job? Is the error "board model not found"? I have had instances where I taught the Fids. and it still didn't like them in production. Is the board fid. in the center of the screen when you try to run the job?
Electronics Forum | Sun Jun 26 12:03:38 EDT 2005 | geb
Re: 23-Jun-05 16:09 (pr) It is a pad, cos the fids on the PCB are in a different place to the ones on the stencil.
Electronics Forum | Thu Jul 21 01:29:07 EDT 2005 | matjen
We are using Fuji-Flexa software and we are not sure where to go in the software to check the proper data. If anyone has Fuji-Flexa software and could direct us in the right direction please let me know. Thanks.
Electronics Forum | Thu Jun 23 16:09:51 EDT 2005 | pr
Oh Yeah, I've had an AP27 I would say it just doesn't like your fid. Just click on the window in the bottom left and it'll go full screen (then click main menu to return). Check the easy stuff first, Make sure you have a consistant load (in the cente
Electronics Forum | Thu Jun 30 05:22:11 EDT 2005 | dougs
it's been a while since i've worked on a CP6 but there is a sensor around the X-Y table ( near the back, it's not attached to the table, it sits just below the turret area )that tells the machine if there is a board there, i think you need to set thi
Electronics Forum | Fri Jul 08 10:11:44 EDT 2005 | Luke Mittur
Hello When the table goes back to loading position, it checks for the avaialbility of the board. It is possible that there is a component right under the PCB confirm sensor and the sensor is not able to recognise the board, so it unclamps . No
Electronics Forum | Fri Jul 23 12:47:20 EDT 1999 | Bill Schreiber
Dear Earl, At Smart Sonic, we have seen fiducial deterioration as a result of the epoxy not being water-safe. Unfortunately, many stencil manufacturers believe their customers are still cleaning with solvents and therefore use an epoxy that is solve
Electronics Forum | Tue Jul 27 17:12:11 EDT 1999 | Earl Moon
| Dear Earl, | At Smart Sonic, we have seen fiducial deterioration as a result of the epoxy not being water-safe. Unfortunately, many stencil manufacturers believe their customers are still cleaning with solvents and therefore use an epoxy that is s
Electronics Forum | Tue Jul 12 03:57:55 EDT 2005 | woodglass
Hi, In the CP6 propers, there are values: PCB Check Position X, & PCB Check Position Y. These are the servo counts that the X/Y table moves to when checking if a PCB exists on the table. Your sensor does not detect a PCB, probably because when checki