Electronics Forum | Wed Apr 24 12:55:26 EDT 2013 | markhoch
Our Safety Committee has tagged the Fixture Changeover process as potentially unsafe due to the weight of our ICT Test Fixtures. (They range from 40-60lbs each) I've been tasked with investigating a lift, (aka a "cherry picker"), to assist in loadin
Electronics Forum | Thu Aug 09 16:51:39 EDT 2018 | tey422
A good set of fixtures are what you need to get it done right. Since we are in the same area, I would recommend give ATD (Advance Tooling Design)a try, they located in San Jose. We been using fixtures from them for years. We build thousands of Fle
Electronics Forum | Fri Aug 10 16:01:51 EDT 2018 | ks0707
Hi Thomas, Thank you for your advice. BTW, unfortunately, I received negative answer from the Fixture house same as below. =========== We have an issue here. Your board is too thin. It is fine to make the fixture for first side. But when you run
Electronics Forum | Thu Sep 14 14:08:41 EDT 2000 | Bob P
We are currently looking for a new vendor who specializes in selective wave solder fixtures within Southern New Hampshire or Mass. Can anyone recommend a good supplier(s)?
Electronics Forum | Fri Sep 15 09:13:18 EDT 2000 | bobbemc
Bob, We are a manufacture of selective wave solder fixtures. I would like an oppurtunity to offer you assitance. Please contact me at 215-340-0650 x234. Look forward to hearing from you. Bob Baginski EMC Global Technologies bobb@emcgti.com
Electronics Forum | Fri Sep 15 16:41:43 EDT 2000 | Dave F
Consider searching the SMTnet archives for the source you seek. Several wave soldering fixture suppliers are listed there.
Electronics Forum | Wed Sep 20 09:25:30 EDT 2000 | Chris McDonald
EMC is good. Every fixture i have gotten from them has been profesional. Now only if I could get a 3 day turn. : )(I have but customs has held the pallets up! )
Electronics Forum | Wed Sep 20 15:10:02 EDT 2000 | jackofalltrades
We use Datum Dynamics for selective wave pallets and have been very happy with their work and fast turn around. We also get all our press fit fixtures from them. Check out their web site www.datumdynamics.com
Electronics Forum | Wed Mar 15 21:52:33 EST 2000 | Chuck Garth
A long time ago I had seen wiping fixtures in which the circuit board was placed and fingers bent the leads on the components. Can anyone supply me with their design. I can almost see them work but am missing on the finer points
Electronics Forum | Wed Jan 31 14:14:02 EST 2001 | chugarth
I recently purchased a 2275 Gen Rad In Circuit Tester. It was orginally thought that we would get the Test fixture and Test program from the current board manufacturer. Now it doesn't look like that is so. Is there anyone besides Gen Rad that makes f