Electronics Forum | Fri Apr 17 21:46:18 EDT 1998 | Matthias Mansfeld
I plan to design a multichip module which contains 1 chip with about 200 pads and 2 chips with about 50 pads, no other components.The whole module shall replace as intermediate solution a single chip CPU in QFP208. Thus, the MCM itself must have t
Electronics Forum | Tue Sep 13 09:50:06 EDT 2005 | slthomas
"I think the best is to make sure the oven profile and other factors are set up so as to avoid any opens in the first place." I think you answered your own question. The difficulty (from my limited experience, anyway) in adequately qualifying your
Electronics Forum | Mon Nov 09 07:21:02 EST 2009 | CL
Good Morning, I have seen many posts regarding BGA voiding being excessive and what can be done to better the condition. I have a customer that has an assembly that we have had a diufficult time with. We have spent a lot of time debugging the proces
Electronics Forum | Thu Sep 17 12:00:19 EDT 1998 | Mike C
| | I need an evaluation process to prove to a customer that our no-clean process does not leave excessive residue? Any ideas? | Wayne: More of the same as Chry and Justin. | KEY ISSUE | The first thing that you need to know is: What does your cus
Electronics Forum | Tue Jan 16 20:34:17 EST 2007 | davef
DAVE�S BOOKSHELF ASSEMBLER�S ESSENTIALS Title: Soldering in ElectronicsAuthor: RJ Klein WassinkPublisher: Electrochemical PublicationsISBN: 090115024XPublication date: December 1989 I know, I know. The book was written in 1989!!!! I use this b
Electronics Forum | Thu Apr 02 13:18:18 EST 1998 | Sylvia Ireland
Does anyone know what the military uses for water soluable flux in their wave solder process: - wave flux - rework flux - cored solder and approval steps to go through to qualify it. Any information is appreciated. Thank you.
Electronics Forum | Mon Feb 04 12:30:25 EST 2002 | fmonette
Dave highlighted all the elements that must be considered to determine the optimal temperature and duration for a pre-rework PCBA bake process. As far as the component is concerned, it really depends if you care about not damaging the package for r
Electronics Forum | Wed Jun 05 14:43:33 EDT 2002 | davef
Steve, As a reason for cleaning no-clean flux res: Well, maybe some of Por's products / customers can live with NC flux res, while others cannot accept it. So, rather than running two fluxes Por finds it simpler to clean the NC flux res. For us,
Electronics Forum | Thu Apr 10 14:35:18 EDT 2003 | russ
What flux are you using to put them back on? you should be able to adequately clean the site after removal with alcohol or water depending upon the type of flux. "White grungy" usually comes from a liquid flux such as Alpha 857 being squirted on th
Electronics Forum | Mon Jul 19 08:52:02 EDT 2004 | Omega
Try spraying flux on top of the loaded PWB when you put it on the conveyor. The tackiness of the flux does a pretty fair job of keeping the axial leaded parts down to the board. This takes more cleaning, but it has worked wonders for me on assemblies
