Electronics Forum | Thu Jul 10 13:24:59 EDT 2014 | sargeredarmy01
Ok so here is where I am with everything. I pulled the cylinder and cleaned it out. Didn't find anything out of the ordinary inside. I set everything back up and tested it. Still nothing. I went into the I/O map and tracked down that input, I then
Electronics Forum | Thu Sep 09 08:33:07 EDT 1999 | Dave F
| My company is looking to perform "real time" statistical process control on our current SMT operations. I have identified the critical processes for SPC but have not had much luck in finding a system(s) that can monitor the required processes for m
Electronics Forum | Thu Jun 30 05:22:11 EDT 2005 | dougs
it's been a while since i've worked on a CP6 but there is a sensor around the X-Y table ( near the back, it's not attached to the table, it sits just below the turret area )that tells the machine if there is a board there, i think you need to set thi
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Wed Jan 02 12:03:13 EST 2019 | jdengler
They go through TN-3 to get to the TSA-200A D/A module. This is all in the MTU. It's been a long time since I worked on an IP-2 but see if you can get to the I/O screen for the MTU. Have someone flag the in range sensor and see if the input status on
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723