Electronics Forum | Tue Dec 01 17:50:43 EST 2009 | swag
This is cut and paste from a Conceptronics Document - hope it helps you: Following are the lubricants recommended for oven maintenance: 1. To lubricate the conveyor chain use: A. Biral BIO30 -synthetic high temperature oil (highly recommended)
Electronics Forum | Wed Feb 20 12:50:32 EST 2008 | soudomphong
Where can I get Tribol 1421/SG high temp chain Oil? Thanks, Seth
Electronics Forum | Wed Jun 21 14:14:43 EDT 2000 | Gary Hunt
I need to construct test boards for which will be repeatedly subjected to Highly Accelerated Stress Screens, (HASS), and am looking for recommendations for materials. Would an Epoxy Glass or an Epoxy Glass Composite be least suceptible to exposure t
Electronics Forum | Wed Apr 26 09:39:44 EDT 2006 | russ
Sorry, If you need to do this, I would run a high temp alloy in the first side and then a lower temp on the second side. Components must be able to withstand the high temp process for the first side. Russ
Electronics Forum | Fri Feb 15 06:21:34 EST 2008 | marjorie
Thanks for the comments and advice. The rest of the components have good solderability except for the BGA that fell off. Our production is high mix low volume so the quantity was very small. I'll check the pcb lands next time I run. It could be a con
Electronics Forum | Thu May 13 14:41:17 EDT 1999 | Michael N.
I need some pics or documentation on how a finish soldered joint looks like for SMT component. I have various people who supposedly says has knowledge with High Temp says my joint could look better. The joint looks shiny and great except for a grainy
Electronics Forum | Thu Jan 31 06:38:55 EST 2008 | cobar
Wave too high,pot temp to high set to 245�C. Solder level too low.
Electronics Forum | Thu Apr 19 23:53:32 EDT 2007 | Haris
NOTE: VIOS format takes less memory than XML format. VIOS to XML on YV100Xg Click EDITOR button. VIOS data appears, click your desired file name then click PCB DATA in the menu and click SAVE PCB DATA OF XML AS, give name with the extension .xml MY
Electronics Forum | Mon Jul 01 16:34:46 EDT 2013 | wpierowski
So that is common when the temp on the wash is high? The temp was adjusted for a flux that required a higher temp. How much of an issue is this tin oxide?
Electronics Forum | Fri Nov 03 13:48:39 EST 2006 | monty
I have a BTU Reflow 8 stage (PCDIU software) oven. The max temp. that it will allow is 270 degrees. I am trying to use a High Temp solder paste and the profile states that I must go between 260 and 270 degrees. My question is, is there a way to incre