Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri May 07 21:31:52 EDT 2021 | sosigguy
Have you checked WinMCS? it's the software in windows that controls the machine. if you open it up it might have thrown some error codes, i believe it has some diagnostics in it aswell.
Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake
Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.
Electronics Forum | Sun Feb 24 22:01:06 EST 2013 | mdang
Hi, I bought a used FUJI CP65 machine and the machine is lockup in home. I boot the machine up with Mecha-check mode and can home all the axes except FRQ axis. I look at the Clutch Origin and Messh-check sensor amp is it display 1,2 E (Error I think)
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
