Electronics Forum | Thu Dec 16 04:14:16 EST 2010 | kemasta
Hi, I am new in this industrial. I learnt that PCB may absorb moisture and eventually caused delaminate after heat apply on it (reflow or wave). But I don't quite understand, if the PCB was keep in sealed bubble bag, and with the humidity control wit
Electronics Forum | Mon Mar 15 23:00:40 EST 1999 | Dave F
| In the early days, we used screens made of stainless steel or polyester. Sometimes - after A period - the tension was not good, because A wire was broken. | Later on we started to us metal stencils, glued in A polyester screen. even than we had som
Electronics Forum | Tue Mar 16 08:38:59 EST 1999 | George Verboven (Process Engineer)
| | In the early days, we used screens made of stainless steel or polyester. Sometimes - after A period - the tension was not good, because A wire was broken. | | Later on we started to us metal stencils, glued in A polyester screen. even than we had
Electronics Forum | Tue Jun 19 17:33:09 EDT 2001 | genny
We don't actually leave the residue on the board, even though the Kester spec sheet says it is ok not to clean - we do spot hand cleaning with Safety Wash. Kester also said that there shouldn't be any problem with mixing RA with no-clean, although w
Electronics Forum | Sun Jun 20 16:45:48 EDT 1999 | Chrys Shea
I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something), and
Electronics Forum | Mon Jun 21 12:08:17 EDT 1999 | C.K.
| I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something), an
Electronics Forum | Mon Jun 21 15:27:00 EDT 1999 | Tony
| I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something), an
Electronics Forum | Mon Dec 17 19:01:45 EST 2007 | bbarton
As someone with a LOT of experience with the "low cost" alternative alloys, primarily SACX, I have one simple question....Are these shorts a new phenomena? WAS your process in control, and all of a sudden it's not? If the answer is YES, take a look a
Electronics Forum | Thu Jul 01 19:13:48 EDT 2021 | SMTA-64387161
Welcome to SMT! I highly recommend exploring the process of adding unique reel identifiers to your reels and tracking locations, or even kitting, using these barcodes. You may also see this referred to as serializing or license plating. Implementin
Electronics Forum | Fri Nov 24 18:38:41 EST 2023 | ethanappgenius
Hey there! It seems like you're encountering a couple of issues with your Juki, and I'm here to help. The error code 696007 on your Juki typically indicates a problem that might require adjusting the date and time settings on the control panel. Howev
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723