Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Sat May 15 11:27:26 EDT 2010 | davef
We'd expect both OSP poor wetting and improper reflow recipe to show-up in more places than just this one component. But if those are the only choices, we'll go for 'wrong solder paste.' Ooops, that's not one of the choices. Ok, OK, we'll take poo
Electronics Forum | Tue Dec 17 13:42:04 EST 2002 | robf
There are a few emerging technologies that have been growing in popularity for the past few years. Pin through paste, press fit connectors and selective soldering machines seem to be displacing custom fixtures. Most of the mixed technology boards o
Electronics Forum | Fri May 14 09:00:35 EDT 2010 | rafacadiz
I attached a RX picture. A lot of voids and micro balls arround the flux residue. What do you think, relow temperature reflow or OSP poor weeting.? I appreciate your comments. Thanks,
Electronics Forum | Tue Dec 17 08:38:30 EST 2002 | Randy Villeneuve
Jim, In most cases if you can eliminate a process you will save money. With that in mind, an all surface mount or all through hole design is prefered. There are alternatives to that rule, like hybrid designs that can be pin and paste soldered. It al
Electronics Forum | Sat Feb 20 09:56:22 EST 1999 | Tufty
| We are in the process of getting into no-clean paste and fluxes. One important issue in this is sodler balling. I have heard some people say that having a matte finish would help in having lesser solder balls and that the solder balls would not b
Electronics Forum | Mon Nov 14 10:10:52 EST 2005 | davef
When soldering your full tin (no lead) and Pb95/Sn5 solder components, you need to modify your PbSn reflow recipe to compensate for the higher melting point of the changed solder alloy [with your Sn62/Pb36/Ag2 solder paste] on those component leads.
Electronics Forum | Mon Nov 15 12:09:55 EST 1999 | Dave F
Steve: Continuing with Dan�s thinking, generally, "poor release" (paste hanging-up in the stencil holes) could have three main (or combination of) causes: 1 Equipment: Stencil is too thick. Specifically, your 0.006 should be OK, providing you don�
Electronics Forum | Thu Nov 10 08:23:35 EST 2005 | arclightzero
Hello, I am currently trying to isolate internal fallout problems with very low yield substrates mixed with great yields and have recently found that we are using a Sn62/Pb36/Ag2 solder paste with full tin (no lead) components as well as Pb95/Sn5 sol
Electronics Forum | Mon Sep 18 19:58:10 EDT 2000 | Dave F
broad answer. There's tons of suppliers. Go to "Circuit Assembly" magazine web site and look-up flux suppliers in the "Buyers Guide." Broad line suppliers are Kester, Alpha ... They will make you answer: I'm joining bla, bla, bla metals, using b