Electronics Forum | Sat Jul 26 12:04:32 EDT 2008 | davef
Services, Recycling, Electronic boards * American Scrapmetal; 7120 Rufe Snow Dr, Suite 106-184, Fort Worth, Tx 76148; 817-891-5297 americanscrapmetal@hotmail.com http://www.americanscrapmetal.com * Clean Harbors, Inc; 1501 Washington St, PO Box 8590
Electronics Forum | Mon Feb 20 23:01:05 EST 2012 | davef
Services, Recycling, Electronic boards * American Scrapmetal; 7120 Rufe Snow Dr, Suite 106-184, Fort Worth, Tx 76148; 817-891-5297 americanscrapmetal@hotmail.com http://www.americanscrapmetal.com * Clean Harbors, Inc; 1501 Washington St, PO Box 8590
Electronics Forum | Sat Feb 19 23:47:46 EST 2000 | Dennis O'Donnell
Call Ken Gribble at (408) 383-0704. He is the SRT Rep. for the San Jose, CA area. I just purchased an SRT from him about 6 months ago. SRT is top of the line. I haven't heard of the model you referenced. You want to make sure that your not gettin
Electronics Forum | Wed May 03 20:01:44 EDT 2000 | Dave F
Joe ... What is it with you and bent leads, bud??? One angle that you might take is taking to folk that reclaim components from stuffed, but obsolete boards. Try: Chip Pro 10390 E. Lakeview Drive #206 Scottsdale, AZ 85258 480-860-5790 Fax 8366 Pro
Electronics Forum | Sat Feb 19 23:47:46 EST 2000 | Dennis O'Donnell
Call Ken Gribble at (408) 383-0704. He is the SRT Rep. for the San Jose, CA area. I just purchased an SRT from him about 6 months ago. SRT is top of the line. I haven't heard of the model you referenced. You want to make sure that your not gettin
Electronics Forum | Mon Feb 07 13:40:41 EST 2000 | Dave F
Jose: Those are good guesses. Without knowing more, ask yourself: 1 There is probably adequate heat available, but that portion of the substrate that�s not soldering well is not receiving proper heating. Why is the component getting so hot, relati
Electronics Forum | Mon Feb 07 19:49:50 EST 2000 | Tony Di Mauro
Jose, I have seen this defect before. We called it re-reflow. We found the part was originally attached at SMT. Later on after seeing a heat cycle at the wave machine the leads would de-attach causing an open at In-Circuit Test. Resolution was t
Electronics Forum | Fri Sep 10 13:50:24 EDT 1999 | Jose RG
We have a product, with various PWBs, with over 600 parts each one (We are a low Volume/high mix company with an average component placement per PCB between 250 to 300 parts). This PWBs have 7 to 10, 20 mils pitch parts. We are having problems with o
Electronics Forum | Fri Sep 10 14:29:48 EDT 1999 | Doug Philbrick
| We have a product, with various PWBs, with over 600 parts each one (We are a low Volume/high mix company with an average component placement per PCB between 250 to 300 parts). This PWBs have 7 to 10, 20 mils pitch parts. We are having problems with
Electronics Forum | Fri Jul 30 19:19:21 EDT 1999 | M Cox
| So is anyone going to attend Nepcon Texas in Dallas, or is it a waste of time? | | So far I don't see some of the big players, and I would assume they would have their trade show dollars mapped way in advance. | | Being in San Antonio (should I