Electronics Forum | Tue Jul 29 10:46:17 EDT 2008 | realchunks
Oh, well if you can profile, model your profile to the profile supplied by the paste manufacturer. Anything outside of their recommended profile is all experimantal.
Electronics Forum | Tue Dec 04 09:48:43 EST 2001 | davef
Defining the thickness of solder between the lead and the pad, J-001 states "Properly wetted fillet shall be evident." J-001 is available from http://www.ipc.org. Factors that affect this are: * Amount and composition of solder * Amount and compo
Electronics Forum | Wed Apr 06 08:27:12 EDT 2011 | kaschliman
Our two component suppliers use 99.5Sn/0.5Cu and 97Sn/3Ag solder (respectively) for tinning their leads. We use 98.9Sn/.66Cu/.33Ag solder in our wave solder machine. Is there any significant advantage to either tinning process regarding solderabili
Electronics Forum | Mon Jul 28 16:48:54 EDT 2008 | pcbbuilders
my oven has a built in profiler, it works fairly well, but it can not predict changes. my main concern was about the time right before reflow. i know that's where the flux is activated and i was worried that i may be spending too much time at the tem
Electronics Forum | Fri Aug 01 21:10:35 EDT 2008 | leo_dektec
You can keep only the 5th zone as the reflow zone. And lower the first two zones to keep a good ramping rate. Meanwhile,please note the ting temperature in software or control panel is not the exact temperature in your PCB, you'd better get a KIC or
Electronics Forum | Fri Jul 25 15:54:22 EDT 2008 | pcbbuilders
I am trying to optimize my reflow profile. i have a 5 zone oven. lead-free: for the 1st 3 zones, i am good, at about 150-200 deg for 150 seconds. during the 4th zone, i am at a temp of 200-220 for 50 seconds. during the 5th zone, i am at 220-245 f
Electronics Forum | Thu May 29 17:48:00 EDT 2003 | jonfox
As far as I know, the limitations apply to to the manufacturing components, not the equipment per say. At this point there is no set date for the US at the national level. Basically our government is run by big businesses and their effect on our na
Electronics Forum | Sat Jul 26 07:42:49 EDT 2008 | pcbbuilders
I am not very concerned about production time, but it is always a thought! Quality is more importnant of course. We have 2 different pastes, with almost identical requirements. We can get close to their profiles, but i am worried that i am spending
Electronics Forum | Mon Jul 18 12:24:53 EDT 2016 | oleksz
Some people involved in PCB assembly process claim that SMD components reflow soldering problems are often caused by traces running under a component. According to this claim, trace (or any copper) covered by solder mask and placed under SMD componen
Electronics Forum | Mon Jul 18 12:25:30 EDT 2016 | oleksz
Some people involved in PCB assembly process claim that SMD components reflow soldering problems are often caused by traces running under a component. According to this claim, trace (or any copper) covered by solder mask and placed under SMD componen
