Electronics Forum | Fri Jun 29 09:58:35 EDT 2001 | edmentzer
We use 30 and 32 gauge PTFE wire. The insulation will not melt with normal hand soldering temps. The wire was made by Thermax/CDT. Their phone number is 800-423-5873. The only problem with the wire is that is hard to glue to the board. We use Ta
Electronics Forum | Tue Nov 30 18:33:05 EST 1999 | Brian W.
I have used Loctite, RTV3145, or Tak-Pak to secure the wire. As John said, the wire is usually secured to the board near the lifted lead, and usually at 1/4 inch intervals along the way. Brian W.
Electronics Forum | Wed Oct 06 20:46:10 EDT 1999 | Mike Cooper
We have same equipment and used the same adhesive. Switched to Loctite 3618 and problem went away. Check cure profile again. 150C at 90s best. Also, check dot size/patterns. Double dots for chips and 4-dot for SOTs works well for us. Regards.
Electronics Forum | Wed Aug 25 13:13:13 EDT 1999 | Chad
I AM LOOKING FOR ANY INFORMATION ON THE AMICON,EPIBOND AND LOCTITE ADHESIVE. IS THERE A 3RD PARTY COMPANY ANYWHERE THAT HAS DONE TESTING OF THE THREE VENDORS MENTIONED. CHAD
Electronics Forum | Fri Mar 15 10:00:40 EST 2002 | BLN
We screen print on half of our 15 lines with no problems. We're currently using Ciba 7275, but are looking to change to Loctite 3616 (lower cost).
Electronics Forum | Wed Jul 24 16:36:53 EDT 2002 | russ
If you have a board router then I would reccomend an epoxy to re-attach the boards. If not try a high temp loctite russ
Electronics Forum | Mon Dec 02 00:42:13 EST 2002 | mjabure
It probably would have been fine, but nobody can find fault with your following the manufacturers recommendation. It would have been worse if you hadn't and a problem occurred.
Electronics Forum | Wed Feb 19 17:34:21 EST 2003 | btoleno
I have a paper that was presented at the SMTA technical session at Nepcon West in Dec on screen printing adhesives. If you would like a copy send me an e-mail at brian.toleno@loctite.com and I can send you an electronic copy.
Electronics Forum | Tue Jan 13 12:06:23 EST 2004 | blnorman
Can't tell you based on sales, but here's a list I know of: Kester Alpha Metals Aim Indium Multicore (Henkel/Loctite) Qualitek
Electronics Forum | Wed Apr 07 13:02:05 EDT 2004 | Marco Serrano
Had anyone experienced air bubbles inside of the Loctite glue syringes? If any of you do What have you done to rid off this problem? Thanks in advance!