Electronics Forum | Wed Mar 25 18:34:34 EDT 2020 | spoiltforchoice
> What about designators? Using gerbers to program > a pnp machine was always a last resort to be done > only after much complaining and begging for > proper CAD data. Back in the day I used UniCAM to > program a mydata. After gett
Electronics Forum | Fri Apr 10 09:59:13 EDT 2020 | spoiltforchoice
> We unfortunately use GERBER data to digitize <BR> > boards more than any CAD. We are CM and many of <BR> > our customers do not provide CAD. With some <BR> > Legacy products, we still use 274-D Gerbers
Electronics Forum | Mon Apr 17 22:54:51 EDT 2006 | Darby
Short answer is - not really. According to the manual in Chapter 1-5 Supply devices (Feeders) overview "There are also available an 8mm tape feeder which handles 1005(0402) square chips". I have never seen one. The problem is that even an H nozzle is
Electronics Forum | Sat Sep 23 21:52:51 EDT 2017 | jlawson
In most cases PnP files are all that is needed for SMT program generation. BUT, it depends on origin reference of this data as exported to PnP and could be off in X,Y and rotation of image pending when PnP Data is exported. Also Rotation of parts
Electronics Forum | Thu May 12 01:20:48 EDT 2016 | darby
Check your interface boards and connections. Should be in your manual under "control rack/ board connection/ " then they have the various I/F boards. I don't know the initialisation sequence, but a PC whiz or Samsung should be able to tell you the or
Electronics Forum | Wed Dec 14 12:48:21 EST 2005 | grantp
Hi, A second hand TP9-2U MYDATA could be picked up very low cost, however it will only load a single component at a time, which could be ok for your jobs. However if your running 0402, I am not sure if that model will do it accurately. Your machin
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Wed May 24 17:09:05 EDT 2000 | Chris McDonald
We have A V-Tek using pressure sensitive cover tape but the only success that we have found is with SO-8, S0-14, SO-16 anything wider and the tape pulls apart when on our feeders. ANything over 16 wide is not recommened unless you get a heat sensitiv
Electronics Forum | Fri Jun 16 00:45:19 EDT 2006 | Richard Robins-Bird
Not all splicing tapes require the use of specialist tooling or splicing plates to make a join. Please see wwww.fujismt.com where a complete range of SMT splicing tapes (Joint Tapes) can be found for use with chip mounters such as Assembleon, Europla
Electronics Forum | Tue Sep 20 16:19:44 EDT 2005 | gregp
Hello all, I am looking for a general opinion on splicing tapes. It has always been my opinion that splicing was an after thought for the machines that did not allow feeder removal and replacement during machine operation. If the machine has the ab