Electronics Forum | Wed Jun 29 17:38:16 EDT 2005 | GS
Several years ago, we had almost same pbm, best results have been obtained by using water soluble paste (those time the old AM1208). Any way, to get a good toe meniscus is not so easy. Talking about CTE, keep in consideration the internal die of TSO
Electronics Forum | Tue Jul 25 12:14:39 EDT 2006 | russ
All my studies led me to believe that it was CTE mismatch of this package. Altera was of less than 0 help in this matter. The other possibility was an ICT test fixture. Unfortunately (?) the design life of this product was at end and the new design
Electronics Forum | Thu Jul 12 20:20:31 EDT 2007 | seankim10
I�m having problem with PCB with 16mil thickness due to warpage. the board convex up in the middle after 1st reflow. It seams the warpage is caused by CTE mismatch between PCB and multiple TSOP's, which are covering ~80% of the bottom side board area
Electronics Forum | Fri Jun 10 13:04:04 EDT 2011 | spitkis2
Any suggestions as to what can cause a PBGA's corner to warp down during installation process on a rework system? A couple solder balls bridge at the corner. It appears at the pin 1 corner where the metal indicator of a BGA is exposed. I am wonder
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Fri Nov 22 11:31:52 EST 2013 | igorfo
Hi I aa QE on SMT line that produce products for Home introduction. No so long ago we have a problem with soldering of BGA Head on Pillow (root cause mismatching customer requirements and BGA profile spec, suplier change %Ag) and our product affect
Electronics Forum | Fri Oct 10 20:56:50 EDT 2014 | jlawson
Main issues... Pad Design Thermal Mismatch Design related to pads effected Moisture and out gassing in substrate / part terminations can move parts slightly during preheat prior to liquidous this get position shift ( smaller the parts more an issue)
Electronics Forum | Wed Nov 16 21:35:07 EST 2022 | stephendo
" so I wander what can I do to save them?" The boards or management? Seriously I think this is more of a management issue than a technical issue. We can suggest what to do but if management does not accept that solution then it won't work. I'm not s
Electronics Forum | Fri Sep 11 09:45:39 EDT 1998 | Earl Moon
| I'm very familiar with the great board space savings of BGA and all the "claims to fame." However, can someone out there tell me if any concern exist in the inspection realm. Additionally, solder cracking, CTE/TCE mismatches, no leads for stress re
Electronics Forum | Sun May 17 13:46:30 EDT 1998 | Steve Gregory
Hi All! I've been reading this conversation which prompted me to break out the IPC-SM-786A from the IPC manuals from our parent company in Maryland sent us (we're just starting up in California). It's the Procedures for Characterizing and Handling of