Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Wed Mar 04 13:45:01 EST 2020 | tomdegas
I appreciate the help. The Hydra travel is fine and goes down and back up with no trouble. I swapped the Z Mot board with the Y Mot board with no change. The long ribbon cables were changed about a month ago but I will inspect them again to be sure.
Electronics Forum | Tue Apr 02 17:56:44 EDT 2024 | mistrthou
You'll need the specific Mydata part. It has some specific dots and square printed on it. It should be in a box with other calibration parts, stuff which we do at least every 6 months. I attached an internet picture of the box that contains the diff
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Tue Apr 02 19:13:02 EDT 2024 | mistrthou
Nice. BTW, I found a pic online. https://www.flasonsmt.com/Uploads/6528ca4e9c5b7.jpg I'm surprised it doesnt have that stuff underneath the machine behind the large panels. Thats where we kept ours.
Electronics Forum | Mon Apr 08 18:16:20 EDT 2024 | mistrthou
We had a Mycronic tech in adjusting rings to get us within spec. He was saying the emitter/receiver board at the top and the tubes themselves can go bad. Between that and having weak latches, we're looking at a refurbished unit. But we're rocking a M
Electronics Forum | Thu Mar 28 17:00:32 EDT 2024 | kingkelvin
For the hydra camera z-level - there is short section in manual - mentions using metal ruler to cover the camera - but for the other cal steps - I see nothing in the manuals for instructions - so I don't know if any special jigs are needed? I don't h
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Mon May 06 14:55:58 EDT 2013 | dyoungquist
We had that problem on our M12. There were a few components that had gotten dropped into the camera area as the hydra head past over it. Our MY12 has a knob towards the front of the machine in direct line with the camera. Pulling this knob release
Electronics Forum | Mon Jun 15 17:54:38 EDT 2015 | catsem23
Hi I have been having a problem with my Hydra tool reference plate. Machine keeps stopping and comes up with error message - failed to locate hydra tool reference marks & Error mounting component .... from feeder ..... with nozzle .... I have check