Electronics Forum | Wed Oct 24 10:02:17 EDT 2018 | tech1
That error points to a hardware issue. When it fails does it ask you to insert a tool manually?
Electronics Forum | Fri Mar 20 01:09:26 EDT 2009 | padawanlinuxero
Have the same problem but I do it manually in MYDATA when I check the feeder�s position I can change the orientation there.
Electronics Forum | Tue Dec 18 21:47:14 EST 2012 | jaimebc
So just to update and close this thread, it was the ZFIB board ( the one mounted on top of the theta motor) that was causing the theta motor to error out) Problem fixed. $ 30 dls or so from MYDATA. Hope this helps some one down the road.
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Fri Oct 08 14:27:54 EDT 2004 | M_Oniah
Many problems with the APS feeders and controller. We replaced it with Mydata. Much better.
Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Tue Jun 19 16:19:34 EDT 2007 | bk
There are no batteries in mydata magazines. This problem means your voltage is outside it's allowed range. In this case I think it's the 15 volts. If you open up the bottom of the machine and pull out the carriage you'll see a rectangular box that ho
Electronics Forum | Thu Jul 11 21:35:24 EDT 2002 | lysik
I am not being denied support. I also have no problem registering a machine to get support. I like MyData machines. I would like to see the wtitten policy.
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
Electronics Forum | Thu May 09 15:33:01 EDT 2013 | shankar2013
No luck yet. Also cannot buy a Cent electrode motor from manufacturer. Anybody know of sources where we can buy spares for TP-9. Thanks