Electronics Forum | Wed Mar 04 14:32:21 EST 2020 | bk
The mot mi board is the first board but it is two boards tied together so you need to undo the screws on the first 2 boards on the left.
Electronics Forum | Sat Sep 02 15:54:46 EDT 2023 | mekmat544
Hello, I would like to ask you for help. We have problem with our Selective Solder System SEHO PowerSelective. Problem is, that Z axis is decreasing. When we start soldering, height of Z axis is correct but after each solder cycle, there is decreasin
Electronics Forum | Tue Jun 26 15:05:02 EDT 2012 | upguy
Thanks for responding Fred and Peter. We have had the same damage to the tip occur even though our TP9-UFP sits in an air conditioned room (74 F / 23 C). I spoke with Matt at MyData (who was very helpful). He said that the X-axis bearings, the X-a
Electronics Forum | Wed Apr 06 05:08:07 EDT 2005 | blueflag
New morning but still the same agro'. The story so far - Have checked the fuse on the back plane and it had blown again, changed it has been ok. Swapped the mot-z board around with piggyback mi card, no new other/moved problems. When doing base cente
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Mon Jul 02 09:30:19 EDT 2007 | cyber_wolf
Make sure that your C14 tool is black and that the tip is in good condition. Next, create a vision package for the 0402. I assume that your machine has a line scan camera.(Use it) 0402's do not mechanically center well unless your C14 and centering u
Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Fri Sep 19 10:35:56 EDT 2008 | mi
No, I don't have Panapro at all. Some Mydata files I've exported end in: *.cmp & *.gen Files saved on floppy from Panasonic MSH II end in: *.MNG, *.POS, *.SET Panasonic program filenames come out as: CF000000.POS CF000001.POS ... Sample quote of
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
