Electronics Forum | Tue Jun 27 08:29:34 EDT 2006 | davef
It sounds like a board issue. With the current site software, you can not attach pix. You need to post the pix on another site [eg, imageshack, villagephotos, etc] and then post the link here. Or if only a couple of folk are interested, just email
Electronics Forum | Tue Jun 26 12:24:24 EDT 2001 | nifhail
Thanx for the reply Dave. We actually had a few thermocouples attached from underneath to see if there is any delta in temperature within the same BGA's ball. They looks OK, with the slope of 1 -2 Deg C,soak at 120 Deg C - 150 Deg C at about 90 sec,
Electronics Forum | Fri Feb 11 01:36:22 EST 2005 | brown
OK I am counting someone knowing this. True or False, if my touch-up operators touch-up the smt solder joints too many times will this make the joint weaker? if yes why? and what happens to my intermetalic layer? I have insisted if it looks good don
Electronics Forum | Fri Feb 11 08:15:35 EST 2005 | davef
It sounds like you already know the answer. Hand soldering is much more stressful to a board than mass soldering, because: * It is more localized and there is no preheat. * It is more difficult to control. [Different connections require different h
Electronics Forum | Mon Jun 25 20:51:43 EDT 2001 | davef
Well, the paste must be OK, because other components don�t have this problem. The board must be OK, because other components don�t have this problem. So, it must be either the component or the profile. I�d speculate that you need to do some work t
Electronics Forum | Mon Jul 26 18:28:10 EDT 1999 | Jon Prokop
Can anyone give me the virtues of SMT package castellations vs. no castellations with particular reference to the ruggedness and reliability of the solder joints? Any references or studies that you can point me to? Also, although I'm in favor of pr
Electronics Forum | Thu Jul 02 11:50:48 EDT 2009 | davef
You should be able to use the wave solder flux that you currently use in your routine operations. Check with your flux supplier for recommendations.
Electronics Forum | Mon Aug 19 17:06:27 EDT 2019 | bulur
Hello Mike, Thank you for your response. This information is very helpful for us. Thank you again,
Electronics Forum | Mon Jan 14 09:15:44 EST 2019 | davef
Suppliers list the contents of their products in a MSDS. Libraries of these sheets are listed online. Look up the product you're using there. A safety data sheet, material safety data sheet, or product safety data sheet is a document that lists info
Electronics Forum | Mon Sep 24 18:03:43 EDT 2012 | rmazenha
Hi, i am using AIM 264-5 No Clean flux for soldering alpaca pieces on PCB boads, but i am having problems: poor filling and no solder. I am using SAC 305 lead free solder. I have tried to change flux pressure, time, ammount as well solder speed an
