Electronics Forum | Wed Nov 09 08:39:59 EST 2005 | smtspecialist
Thanks Avalancher. I had no clue about the fact that Mydata could analyze part for me. Since I'm in montreal it's hard and expensive to get a Mydata guy up here but sending the parts down there would be an great inexpensive solution. I've been over t
Electronics Forum | Fri Jan 27 20:10:16 EST 2006 | peter
hi guys the scenario is: when placing parts which required maximum speed, the cp6 sometimes missing resistors here and there, when checking part data, everything ok i notice that when the machine switching between high and low transport speed, (eg: r
Electronics Forum | Wed Mar 15 11:29:38 EST 2006 | cjd
Anybody ever use SAM to inspect a bare pcb? What can you see? Is the scatter noise so bad you can't even see the copper layers? I would think you could at least see to some depth and then flip the board over. I work in a R&D environment so speed
Electronics Forum | Thu Jul 20 12:05:44 EDT 2006 | vikkaraja
Hi there to all, I have noticed one of my cp is making very loud thumping sound from the table lately. This noise is only from X-axis not the Y at all. Here are the following things that I went through so far: checked if this was due to lack of lub
Electronics Forum | Fri Jul 21 13:13:53 EDT 2006 | vikkaraja
I have checked the lead screw and guide rails. There is't any apparent damaged to any one of them. I was hoping it be the guide rails because they are much eaier to repalce than the lead screw. If I start messing around the lead screw, It would requi
Electronics Forum | Fri Aug 18 14:31:53 EDT 2006 | vikkaraja
I have humming noise comming from my Z axis motor for a while now. It faults out every so often, but not enough to stop production. I even can hear it while machine is in normal production mode. I have replaced the z servo amp. It did not help any. O
Electronics Forum | Wed Aug 22 04:29:48 EDT 2007 | raf_jabil
Has anyone experienced intermittent communication issues with GSM/GDM and PCT conveyors? I have an intermittent issue where sometimes I would hit the ESTOP on the PCT conveyor(downstream) in order to get the board to eject out of the GSM/GDM. I have
Electronics Forum | Tue Feb 05 18:26:34 EST 2008 | janz
Hello, We have FCM base 2 machine (Philips-Assembelon). I am trying to find out whether it is possible to install instead vacuum pump (make noise and power consumption) venturi system. Does anyone try to do this.? What was the result.? What vent
Electronics Forum | Tue Aug 12 08:35:28 EDT 2008 | avalancher
Many years ago... my old engineer used a very simple unit bought at Radio Shack. It was a device that they use in door ways to announce someone was entering the store. It used a beam of light and when the board broke that beam, a bell/ring/noise wou
Electronics Forum | Thu Nov 06 11:12:57 EST 2008 | janz
Hello, One of our pick and place machine uses rietschel vaccum pump. It is making lot of noise. I am in searching alternative solution which could be venturi pumps. Does anyone has experince in changing vaccum pump to venturi system.? What should
