Electronics Forum | Sat Jan 14 13:18:37 EST 2006 | mrduckmann2000
Let's think about this, there former filed service engineers. I bet they got out of field becasue of being laid-off. Typically the NON-Performers are the first to go. Hint hint.....former field engineers! Quad 4C's when they were new to the marke
Electronics Forum | Sun May 31 11:19:19 EDT 2015 | visionbot
Good luck Alexandru. I went through this years > ago and it is a lot of fun. For the next 5-6 > years you will learn a lot about P&P systems, as > you will get your feedback from your > customers(trust me it is going to be a lot and > you will
Electronics Forum | Wed Jul 31 07:51:31 EDT 2019 | ameenullakhan
Hi Dave, lead is 80Pb/20Sn. Top joint off CCGA lead is SN63/Pb37. Thermocouple was placed at center lead of the CCGA and one at the corner lead of CCGA. Ramp Rate Center 1.09 Corner 1.26 Soak ( 140 - 160 deg C ) Center 37sec Corner 38sec Ref
Electronics Forum | Tue May 26 10:52:02 EDT 2020 | spoiltforchoice
No idea, could be a weird translation error, but its certainly something I have seen . For an FLX they just ask for this "5-6 bar, clean, dry, oil free, filtered 2 µm, connection diameter 8 mm", 40litre/min Personally I would go with a mo
Electronics Forum | Mon Feb 19 07:31:43 EST 2007 | jax
Check the nozzle. If these are the only two parts on the board that use a specific nozzle, it's a good place to start. The nozzle is probably not releasing well and shifting the component when trying to retract after placement...
Electronics Forum | Sun May 23 11:02:45 EDT 1999 | M Cox
Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them out with
Electronics Forum | Fri Jul 10 08:50:04 EDT 2015 | jax
Is the feeder working properly... presenting the label at the same location each time it indexes? If yes, I would look at changing nozzles on the machine. sometimes a rigid tipped nozzle cannot maintain suction on thin items like labels that can ben
Electronics Forum | Wed Nov 29 01:20:44 EST 2006 | fastek
Guess- If a component drops at the camera the machine will not proceed to attempt to place it and drive the nozzle into a brick of solder paste. The line sensor will catch the fact there is no component on the nozzle and will retry to pick and place.
Electronics Forum | Tue Feb 20 23:46:38 EST 2007 | Muhammad Haris
hi Jax the nozzle which i am using for these components are also used for large SOPs and other components so i cant blame my nozzles.The problem is, they always shift to some 5 degree plus but some times it place them accurately.
Electronics Forum | Tue Jul 14 14:42:30 EDT 2009 | snsmt
The Tant size is 3528-21. I use type 72 nozzle for it.