Electronics Forum | Wed Nov 29 01:20:44 EST 2006 | fastek
Guess- If a component drops at the camera the machine will not proceed to attempt to place it and drive the nozzle into a brick of solder paste. The line sensor will catch the fact there is no component on the nozzle and will retry to pick and place.
Electronics Forum | Tue Feb 20 23:46:38 EST 2007 | Muhammad Haris
hi Jax the nozzle which i am using for these components are also used for large SOPs and other components so i cant blame my nozzles.The problem is, they always shift to some 5 degree plus but some times it place them accurately.
Electronics Forum | Tue Jul 14 14:42:30 EDT 2009 | snsmt
The Tant size is 3528-21. I use type 72 nozzle for it.
Electronics Forum | Tue Dec 19 09:27:39 EST 2017 | cuervo
have anyone a pick and place made in china with conveyor and 4 or 6 nozzle
Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
Electronics Forum | Thu Jun 06 07:53:51 EDT 2002 | Jim M.
Has anyone had much luck Picking and Placing die with a Panasonic MPA-G3?What special setups or considerations are required? Currently we pick and place one die with our Universal GSM using only one nozzle. The nozzle must be painted white in order
Electronics Forum | Mon Apr 17 22:54:51 EDT 2006 | Darby
Short answer is - not really. According to the manual in Chapter 1-5 Supply devices (Feeders) overview "There are also available an 8mm tape feeder which handles 1005(0402) square chips". I have never seen one. The problem is that even an H nozzle is
Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
Electronics Forum | Sun Jul 12 21:15:31 EDT 2009 | padawanlinuxero
a more general solution is have you done some cleanning in the vaccumm for the nozzles? change the filters or filter?
Electronics Forum | Wed Jul 15 12:44:11 EDT 2009 | thanhnguyen
The Tant size is 3528-21. I use type 72 nozzle > for it. check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
