Electronics Forum | Sat Jul 29 12:52:38 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sat Jul 29 12:51:34 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sat Jul 29 12:51:28 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Sat Jul 29 12:50:31 EDT 2000 | Larry Johnson
Okay, here is the deal. When result is turned on in trace, I have parts that place fine, square as can be. When I turn result off, they skew. This isn't on all parts, I have tried different vision types, with no improvement. Currently using #100.
Electronics Forum | Thu Jun 08 20:02:24 EDT 2000 | Dreamsniper
We have GSM1 model 1995. It's very stable. About their chip shooters, Robert Bosch here in Australia just bought 2 more chip shooters from Universal Instruments. And they already have 8 of those. Looks like it's quite okay. I just read that news abt
Electronics Forum | Mon Jun 18 01:23:07 EDT 2001 | gregH
I have a 10-pin single in line connector that is reflowable. Pin size is 1.0mm and my pcb drill size diameter for the pin is 1.5mm. is it okay for pin in hole process ? I have only 2 pcs of pth components and they are the 2 10 SIL connectors. What's
Electronics Forum | Tue Dec 14 14:49:57 EST 1999 | Larry Johnson
Okay, I have recently found tiny little ball bearings in side our CP4-2. Some have even been reported by operators to be found on top of the PCB while it is running. We have found about ten total so far, any ideas of where these would be comming fr
Electronics Forum | Wed Jun 10 14:00:16 EDT 1998 | Jason Gregory
Okay, here's a stupid question. What exactly is HASL and OSP? We are going to delve into this technology where I work and I want to utilize the wealth of knowledge here to make life easier. Specifically, what are the differences, the advantages, disa
Electronics Forum | Wed Jun 10 13:59:41 EDT 1998 | Jason Gregory
Okay, here's a stupid question. What exactly is HASL and OSP? We are going to delve into this technology where I work and I want to utilize the wealth of knowledge here to make life easier. Specifically, what are the differences, the advantages, disa
Electronics Forum | Mon May 04 22:42:46 EDT 1998 | Phillipf Hunter
Okay, Fuji MTU4 experts...I need a precise way to determin the X-origin and Y-origin of the tray plates. The center of the S-nozzle referenced to the plate corner is very difficult to EXACTLY measure. I need accuracy to pick small QFP28's - otherwi