Electronics Forum | Mon May 16 11:10:26 EDT 2005 | wizy
I look also for new job in SMT area. Machines what i know: MPM APHie paste printer Simens lines (S23, F5, HS60 etc.) Panasert lines (MV II F, MPA-V, MPA G1, HDP) Omniflow reflow soldering Macrotron and Baasel laser engraver PDT3000 PROM programer
Electronics Forum | Thu May 04 02:07:44 EDT 2006 | CW
Hi, There are a couple of Omniflow 7 and 7E that are being used in the production. Recently we found a lot of flux clogging up the exhaust ducts. Anybody who uses the same type of tool who has seen this kind of problem? How can we fix this? Does
Electronics Forum | Thu Dec 21 09:32:35 EST 2006 | Brandon
Does anyone know of a source other than speedline? I know these can be had for $100. Speedline wants $1600. It is a cooling zone blower motor for a cross blow system. Not the same blower you see on the top of the heating zones. This one mounts from t
Electronics Forum | Mon Jan 15 15:42:45 EST 2007 | realchunks
Dback is right. You're missing part of your manual. Once you perform steps 5-7 you should get an indication that you calibrated correctly. Man, it's a cardinal sin to recal conveyors once you have programs adjusted. Why did you feel the need to
Electronics Forum | Tue Jan 16 07:51:23 EST 2007 | leemeyer
I have found a screen in the software that appears to be some setup data for the conveyor. I cannot find any information in the manual refering to this screen. If you open "SCREENS" then "DEBUG DATA" then "CONVEYOR" there are some setup parameters. D
Electronics Forum | Tue Jan 16 11:16:10 EST 2007 | jaimebc
There is another screen where you can select the sprocket size, since we have an Omniflo 7 as well, it may be worth looking into. Go to Set up/Configure/Option/Conveyor. There you will see Options for different Drive sprockets. Ours have 21/55 tooth
Electronics Forum | Mon Sep 10 14:42:42 EDT 2007 | cyber_wolf
How big is the cap ? We successfully reflow caps that measure aprrox .750" x 750" at the base and are .678" tall. The ovens we use are Vitronics XPM's.(1230,1040 and 930) We also process these caps through our Omniflow 10. As stated, oven length wi
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
Electronics Forum | Wed Sep 12 13:11:50 EDT 2007 | nitro
Usually the bearings lock up. I keep one spare blower on hand and change it out when I have one go bad, then take the bad one apart and change the bearings. The bearings are about $4.00 per set and are pretty common. Not too hard to find. I am using
Electronics Forum | Thu May 09 16:54:43 EDT 2013 | smter
We used to have similar issues with large fallout on ours. I have been writing the date on mine for the last few years. We were having premature fallout due to our techs not installing them with proper screw installing pattern, which seemed to be cau