Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Wed Nov 24 06:24:52 EST 2004 | Joe
Hi, I am an Engineering student doing some research on the component/nozzle interface on SMT Pick and Place machines. Could anyone tell me the force at which the nozzle hits the component as it is picked from the feeder or the placement force on a
Electronics Forum | Thu Mar 01 09:09:04 EST 2012 | cbeneat
We bought two of the nozzles from count on tools. The jury is still out. The vacuum thick errors or the lights sticking at this time has dropped, I reduced the air for the vacuum break to a more reasonable level. There is still some work to do on
Electronics Forum | Mon Apr 18 11:45:04 EDT 2022 | dontfeedphils
If you're 100% certain you have the correct nozzle for this package you could check to see if your PnP machine has an option for "Auto Adjust Pickup Position" or something along those lines and try changing it (if it's currently on, try turning it of
Electronics Forum | Mon Apr 18 19:58:22 EDT 2022 | cbeneat
I had the same question. We have custom nozzles made by Count on Tools. I believe we found urethane works the best for the silicon domed LEDs. Have you slowed the feed rate down on the feeder? Also adjust the top tape to the back slot on the feeder.
Electronics Forum | Fri May 13 22:24:47 EDT 2022 | glasscake
Try adding blow after mount before head up if your machine lets you. Make sure your placing the part into the solder paste as that will add some holding force as well. If your tips are spring loaded you can do some 0.5mm additional mounting height.
Electronics Forum | Mon Sep 27 17:18:57 EDT 1999 | Erik
What selective soldering products should I use for a low production rate, high-mix product line? I am looking to get rid of some hand soldering. I have seen exselect (selective soldering pot method), pillarhouse (small flow solder nozzle with robot),
Electronics Forum | Mon Sep 27 17:52:16 EDT 1999 | Scott Cook
| What selective soldering products should I use for a low production rate, high-mix product line? I am looking to get rid of some hand soldering. I have seen exselect (selective soldering pot method), pillarhouse (small flow solder nozzle with robot
Electronics Forum | Tue Sep 28 10:22:29 EDT 1999 | John Susicki
| What selective soldering products should I use for a low production rate, high-mix product line? I am looking to get rid of some hand soldering. I have seen exselect (selective soldering pot method), pillarhouse (small flow solder nozzle with robot
Electronics Forum | Mon Nov 29 16:04:47 EST 2004 | Terrapin Station
They are actually diamond impregnated tips. The tip can be cleaned using a special jig. this will extend the life. these nozzles are from a machine platform dating back to 1997. The RSS can last for 1,000,000 cycles. SA and MA are similiar but requi
