Electronics Forum | Fri Aug 21 04:37:26 EDT 2009 | grahamcooper22
Manufacturers of non hermetic SMT components have to test their devices as per IPC JEDEC 20C to check their reflow and moisture sensitivity. In this spec they pass them through reflow 3 times, then check them for damage and retest their performance.
Electronics Forum | Fri Jun 29 12:47:25 EDT 2012 | deanm
We are experiencing widely varying First Pass Yields for selective soldering. Some boards are near 100% while others are less than 50% depending on the pitch and general complexity of the board. Question: If you are running 100 boards through your s
Electronics Forum | Sat Oct 25 13:36:39 EDT 2014 | sonavc
Hi everyone, hope you can help me with this machine I bought used and after it is set up , it runs good, home position. I can click the tab Start, and Setup. But I can't click the tab I/O , edit or system. Because, I think I can't log in the Level
Electronics Forum | Thu Apr 14 18:28:20 EDT 2005 | darby
We use the standard supports that come with the machine. Print a 1:1 transparency of the first pass side of the pcb including mechanical outline and components. Your customer may need to supply this. Flip this over and tape it into position at th