Electronics Forum | Tue Dec 19 10:25:38 EST 2006 | slthomas
I'm not familiar with that printer so not sure of the support config., but can you plug the openings in the product with some pieces of scrap board (not likely on support pins but workable on a plate) and look for a difference in performance? Does t
Electronics Forum | Fri Sep 18 18:20:45 EDT 2020 | dwl
Count on Tools makes hard foam support block with magnetic bases that work really well. check with them to see if they make them for the SPV. Insert standard: I receive no benefit nor compensation from the aforementioned company.
Electronics Forum | Tue Sep 07 06:49:18 EDT 1999 | stefano bolleri
| | | I agree SB..Fuji feeders rarely get off that much.Are you using | the Auto-Offset function in your Part data?This will | usually keep your pick on Cp's humming! | YES, always use the auto-offset function in each part data (do you also need t
Electronics Forum | Wed Mar 27 02:59:01 EST 2002 | ianccy
Hi, Don't know if some holes can be drilled to yur machine table, if so, yu can make the support with at least 2 pin and plug into the table, better to use aluminium support, easier to CNC. Hope this help
Electronics Forum | Tue Jun 01 17:56:41 EDT 2004 | Rob
I got some information on this support mechanism but was a little unsure how it worked. Let's suppose you're getting ready to run the second side, do you place the board on this support and have the support travel into the printer? Or is the support
Electronics Forum | Tue Jan 13 19:16:03 EST 2004 | pjc
Dedicated tooling uses what MPM calls an "H" tower. You mount the board support plate (dedicated tooling) on top of the H tower. If boards are only single-sided SMT, meaning only components on one side, the board support plate is flat with vacuum hol
Electronics Forum | Sun Mar 12 22:02:40 EST 2006 | Steveo
Personally I think Grid lok is inferior to the new Vacunest system, especially in screen printing. Vacunest is basically a bean bag that conforms to the shape of the PCB and then holds this shape indefinatley under vacuum, until the vacuum is releas
Electronics Forum | Wed Sep 22 20:57:46 EDT 1999 | JAX
| | Question for you SMT guru's out there. | | | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: |
Electronics Forum | Fri Nov 12 06:38:43 EST 2004 | clampron
Good Morning, I feel that the Grid Lock system (with stealth mode) is the best system for absolute support. For us, it came down to spending 5K or 30K. We went with the 5K. The system we got is not perfect but serves our needs. The Grid lock resets h
Electronics Forum | Tue Sep 22 14:33:41 EDT 2020 | majdi4
Thank you @Makersan CO for your input . Am still doing research for a best tool choice.. I want to avoid pneumatic supports because i had bad experiences with it..am looking for magnetic base supports involved in a dynamic movement block .. or someth
.gif)
