Electronics Forum | Mon Mar 12 10:14:35 EDT 2012 | flyingsnow
Thanks a lot for your input. Why do you prefer steel squeegees? We use hard plastic ones.Thanks.
Electronics Forum | Sat Jun 25 09:26:43 EDT 2005 | mskler
What is stencil thickness & what is the pitch of your component.What is your cleaning processor for stencil.
Electronics Forum | Fri Mar 04 15:22:17 EST 2005 | russ
Glad to hear a little success from ya Duckmann! i have stenciled mask in the past and I can tell you that stencils are expensive. They are basically a step stencil, you will need full thickness for the area(s) you are going to apply mask and you wi
Electronics Forum | Fri Jan 28 04:03:51 EST 2011 | grahamcooper22
Print then dispense in the areas you need extra paste. Why can you not use a stencil which has areas etched away around component patterns to thin the stencil down....for example a 150 micron thick stencil etched to 120 or 100 microns in specific are
Electronics Forum | Thu Jan 29 15:27:54 EST 2015 | markhoch
I agree with SWAG on this. Nano Coatings make a big difference on paste release. I found when placed on the topside of the stencil, it also helps to reduce stencil wear, though others complained that it affected the solder roll, so most stencil house
Electronics Forum | Wed Nov 05 15:47:57 EST 2014 | pnguyvu
Hi Bill, Contact Steve Yen with USA STENCILS INC. He'll help you out. He might need to know stencil thickness and type of solder paste, his contact as below. Steve@usastencils.com 714-636-6211
Electronics Forum | Fri Mar 09 15:13:49 EST 2012 | davef
Care must be taken to not apply an excess of material, as the adhesive will flow under the device during placement and curing, and could cause a short. Printer setup: * Don't worry about stencil thickness. A wide range of stencil thicknesses (typic
Electronics Forum | Tue Sep 21 13:43:33 EDT 1999 | Glenn Robertson
| I've had some trouble pasting a test board for a MicroBGA trial. Most of the paste remains in the stencil apertures. | The stencil is 6 mil thick, laser cut and electo-polished. | The apertures are 12 mil in diameter with 20 mil pitch. | We are usi
Electronics Forum | Thu Jan 27 01:21:48 EST 2011 | eliezerk
How can I print two various heights of solder paste on the same board , no space for graded stencil
Electronics Forum | Wed Feb 20 12:47:53 EST 2019 | ccouture
https://murraypercival.wordpress.com/2014/04/08/enclosed-pump-heads-for-stencil-printing/