Electronics Forum | Wed Sep 25 07:53:10 EDT 2002 | zanolli
Send me a drawing or sketch and I may be able to reccomend a supplier. fax: 401-781-5730 phone: 401-785-4110
Electronics Forum | Tue Oct 08 19:02:03 EDT 2002 | mjabure
Have you checked out autosplice? their URL is http://www.autosplice.com. They may be able to help you out.
Electronics Forum | Fri Feb 28 12:08:07 EST 2003 | davef
Paul We don't like to mix metals on press fits. Yano, we do gold on gold or solder on solder, but we don't mix metals [except with imm silver / tin] to avoid electrochemical corrosion. Is that bad information or does AMP think that's not a problem
Electronics Forum | Tue Sep 21 10:16:28 EDT 2004 | davef
Check with your connector supplier, but most press-fit contacts will pierce through Types UR & XY conformal coat (military approved). Acrylic (AR) Urethane (UR) Epoxy (ER) Silicone (SR) Parylene (XY)
Electronics Forum | Mon Apr 04 08:51:17 EDT 2005 | davef
Look here: * http://www.assemblymag.com/CDA/ArticleInformation/features/BNP__Features__Item/0,6493,140679,00.html * http://www.circuitree.com/CDA/ArticleInformation/features/BNP__Features__Item/0,2133,136322,00.html
Electronics Forum | Mon Apr 04 08:55:05 EDT 2005 | jimih280
the pin manufacturer usually recommends the proper hole size. the hole diameter should be from .001" to .003" undersize depending on the design of the contact area on the pin.
Electronics Forum | Mon Jan 22 08:02:34 EST 2007 | realchunks
Wow, that must be a lot of HASL to reflow and block a thru-hole. Sounds like your board house changed their process. Contact your board house about this. Change your incoming spec to look for this a well.
Electronics Forum | Wed Jan 24 16:37:58 EST 2007 | MelS.
Does anyone know of facilities that just perform rework? I am in need of reworking approximately 1,000 panels in the greater Philadelphia area. (two components - one press fit connector, one a samll cap) Any input/advice would be helpful.
Electronics Forum | Thu Apr 10 22:53:58 EDT 2008 | davef
Search the fine SMTnet Archives for postings on press fit like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=19562
Electronics Forum | Mon May 21 03:20:16 EDT 2001 | Abbas Izad
you can use IPC and Compact PCI standards for guideline then it depends on what kind of connector you want to pressfit. each supplier has its own design on pressfit pins like "needle eye", "baby H" etc... It is also importand to use proper equipement
