Electronics Forum | Tue Jan 22 20:39:04 EST 2019 | nikevoo1
Hello, The problem is with NXT head H04. So there are 4 nozzles that take elements and place them on the PCB.The problem is that it does not randomly place the already taken element on the PCB.The nozzle take element and going to place it, but does't
Electronics Forum | Sat Nov 13 00:50:05 EST 2004 | KEN
Place the part on a board with double sided sticky tape. I bet the part is sliding around AFTER mounting. The tape would proove this. Also, are you sure your not dragging on the scrap counter? Maybe the height of the part is just touching the un
Electronics Forum | Wed Jan 23 12:49:44 EST 2019 | nikevoo1
next step, if the nozzle have to take the same component, the nozzle is going to take it and the both components stick together(one over the other) and the nozzle places them like this stick together. So there is nothing in one place, and on another
Electronics Forum | Wed Jan 23 20:01:20 EST 2019 | padawanlinuxero
Hello Sounds to me that the problem might be with vaccum and lot of it, after the component is place theres a small amount of air that pushes the component away from the nozzle in MYDATA we call it a kiss in my facility, have you check that the air
Electronics Forum | Mon Nov 15 23:34:53 EST 2004 | KEN
I have had this problem on tant-D's. Do a memory dump. Re-transmit status and proper. May help....may not. Also, is this the last mount?
Electronics Forum | Wed Jan 23 18:57:09 EST 2019 | nikevoo1
Is it possible to have too much grease on mechanical valves and because of that something has been clogged? Or mechanical valve O-rings to be a problem? https://imgur.com/a/ZHShMAH https://imgur.com/a/SzAWIL0
Electronics Forum | Fri Nov 12 14:26:52 EST 2004 | Kang
Double check if the part's rotation happened before camera or after (pre-rotation). Make sure no grease on rotation clutch.
Electronics Forum | Sun Nov 14 17:17:26 EST 2004 | donb
Also try deleting all unused programs from the machine's memory. Sounds stupid, but we have a CP-3 that likes to misalign components if it has more than 6 or 7 programs stored in memory.
Electronics Forum | Mon Nov 22 05:54:25 EST 2004 | chad
What type of shape data are you using? Is your vision system checking for leads or is it just looking for a square?
Electronics Forum | Wed Nov 24 05:57:31 EST 2004 | chad
If you're using tooling pins, you may check to see that they do not have wear on the sides from boards repeatedly rubbing against them. I have seen this problem several times, you may give it a look. If you're not using them, I'd suggest that you gi
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
.gif)
