Electronics Forum | Wed Apr 27 11:43:32 EDT 2005 | patrickbruneel
Hi Daan, What we did in the time was pareto analyses on all board designs to determine the critical areas (mainly design errors) and only inspect those specific problem areas. Every batch had a copy of the PC board with problem areas marked and only
Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Wed Nov 03 16:16:32 EDT 2010 | briansmi1116
I have a Zevatech 720 that was working great until one day a "E9001 the emergency stop button has been pressed..." error popped up when I turned the machine on. We traced out the circuit and found out what board it went to. I found a replacement an
Electronics Forum | Tue Nov 08 21:56:23 EST 2011 | tpappano
Hi Jeff, both units have DC servos, and both appear to have the same vision system, although #2 has an additional upward-looking camera with a high magnification lens for die mounting. If I could make use of your hex files, that would be great sinc
Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Sun Nov 06 19:20:23 EST 2011 | jeffr
Tom, Does this only happen on one job or all jobs ? If this happens again..you should clear the RAM memory, but changing the 10 year 3v lithium battery on the motherboard should also be considered at the same time. RAM CLEAR PROCEDURE: Power off, rem
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Mon Nov 14 00:13:55 EST 2011 | tpappano
Hi Jeff, I pulled the proms from both machines, copied to disk, re-burned the the old versions with the newer and reinstalled. The ram became scrambled in the upgraded unit on startup, but I did a full restore through the serial port and unit #2 got
Electronics Forum | Mon Aug 05 09:16:39 EDT 2013 | valeriusx
Greetings. I'm having some difficulties in configuring 2 old SIPLACE Placement Machines - 80S-15 and 80F-3. They are already installed, there are no errors on machines computers, but I can't configure connection between these machines and the line c