Electronics Forum | Tue Apr 10 11:36:46 EDT 2007 | Pro 2000 inc.
Hi there, I recently bought a used Samsung CP30V placement machine witch is about the same machine as a Quad QSA30V. We need to replace some defective nozzles, add some feeders and find spare parts. Where should I look for to get all of these. We tr
Electronics Forum | Wed Mar 19 15:24:31 EDT 2008 | operator
I appreciate the suggestions. I don't mean to hyjack this thread. I will try and get some time to look into this while you guys are around. I am knee deep in maintainence overhaul on a QSA-30 right now. Vac sensors not calibrated, oil in the vacuum g
Electronics Forum | Tue May 31 15:29:09 EDT 2011 | leemeyer
I have a QSP-2 which I assume is in the same family as the QSA-30. I compared the diagram that is in the service manual with a board from a 2-C and they appear to be the same. Your best bet would be to contact PPM at http://www.goppm.com. They shoul
Electronics Forum | Wed Jun 01 10:02:56 EDT 2011 | bobpan
Those cards are all different. The c-series stands alone by itself while a qsp2 and qsa-30 mount into a slot. They were all manufactured seperately for each machine. I would purchase a new refurbished one for the 2c machine and forget about the other
Electronics Forum | Mon Jun 11 16:51:32 EDT 2012 | fredc
If the orings are the same as Quad they are .158 ID and .024 thick. These dimensions are in inches. The thread for the Samsung QSA30 is 5.0 X 0.8mm, this may be the same for the CP40. If this is the correct oring size is it special and relatively ha
Electronics Forum | Mon Jul 09 11:52:21 EDT 2012 | bobpan
Does it show the ANC in a position on the feeder base in the screen that has the nozzles/hole positions? When you go to optimize ...there is a screen that has something to do with registered ANC.....There could be something there that is incorrect. I
Electronics Forum | Mon Jul 09 18:29:19 EDT 2012 | btipcb
I have gotten to what I hope is the last step before I can start running product. However, I have and keep receiving an "Invalid Place Position X" error in three steps of the placement program. I have verified that the camera can indeed find these
Electronics Forum | Thu Sep 27 05:47:21 EDT 2012 | bobpan
Check the software version before you buy it. If it is not version 6.75 do not buy it. This is the last version released for this machine and fixes many bugs that made running a panelized board a nightmare. 0603 parts and above is where i would stay
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.