Electronics Forum | Tue Apr 26 07:37:59 EDT 2011 | leemeyer
Have you performed the camera to nozzle calibration ? I can send you instructions for this if you need them.
Electronics Forum | Tue Apr 26 09:46:27 EDT 2011 | veeckm
Thanks for the reply. I have not performed the camera to nozzle calibration. Is this the same as the calibration of the vu3 camera in the manual? If you would please give me your instructions, any help is appreciated.
Electronics Forum | Tue Apr 26 10:14:06 EDT 2011 | leemeyer
The camera to nozzle offset calibration requires that you modify some of the mod codes once the offsets are calculated. This is not part of the VU3 calibration. Send me your email address so that i can attach a copy of the manual for you.
Electronics Forum | Mon May 09 16:32:05 EDT 2011 | veeckm
I got the camera nozzle offset corrected but after the machine runs for a while the offset will drift and its out the specs I set it to. Any help is appreciated.
Electronics Forum | Wed May 04 08:17:57 EDT 2011 | leemeyer
Parts that are the same size can share the same extent #. If you are placing 100 different 0805 components you will need only 1 extent.
Electronics Forum | Thu May 05 07:41:19 EDT 2011 | leemeyer
Yes, what you are thinking is correct. Assuming an 0805 capacitor parts that are picked from the front and back of the machine will be picked at 0 theta. Parts that are on the left or right will be picked at a 90 theta. This way they can all share th
Electronics Forum | Fri May 06 09:39:26 EDT 2011 | leemeyer
Sorry but I have never worked with a machine that has the Cyberoptics system. Have you tried talking to PPM (www.goppm.com), They have been very helpful to me.
Electronics Forum | Sat May 07 07:03:16 EDT 2011 | jimlas53
Thanks for the suggestion, Bobpan. I'll start looking for a replacement coax cable. Would we be better off to look for a Quadalign system and replace the Cyberoptic unit? Doug
Electronics Forum | Tue May 17 16:18:42 EDT 2011 | danaherr
Thank you. I contacted them today. Their tech thinks it's the camera module box, so we're going to order one from them. Thank you again for your feedback. Dana H. Jade Protronix Arlington,WA
Electronics Forum | Wed Jul 06 08:02:54 EDT 2011 | jholif
bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.