Electronics Forum | Tue Aug 07 14:39:55 EDT 2001 | SL
I and my fellows have been long term customers of Quad and recently purchased the nineth, I think, Quad machine a QSV as well as two stencil printers in the recent past. My experience with the Quad Corporation has been outstanding in terms of custom
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Wed Apr 17 16:51:55 EDT 2013 | gosswald
I have not been on this site for a while but I was reading your post on Autoprgram. I have had my share of fun with this program getting a Quad 2C to run I purchased a while back. I had originally tried the DosBox approach but ran into all kinds of
Electronics Forum | Mon Jul 22 12:43:31 EDT 2013 | microaide
I don't think it is a loose camera lens. We are actually off on the position of the Z-rod. It's not just the camera position that is off. We really can't change nozzles because the z-rod misses the hole in the nozzle changer. We have repeatedly clea
Electronics Forum | Wed Jul 08 23:07:18 EDT 2020 | tylerrobertson
Hello, Trying to re-purpose a QUAD feeder for delivering small parts to a scada robot. Wondering if someone could help me out with a pinout for the connector. it's 8 pins Feeder is p/n 12/10-23959B SSA Was able to get the board to power up and flas
Electronics Forum | Fri Jul 19 18:21:17 EDT 2013 | microaide
We recently purchased some used Quad 4C machines. One of them does not seem to keep a stable origin reference point. I teach the nozzle and component pickup coordinates, then suddenly everything seems to be off by .030 to .040 inches in the X axis. I
