Electronics Forum | Fri Jul 23 13:09:48 EDT 1999 | Steve
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Thu Jan 27 06:39:59 EST 2005 | reash
For now, on this first board, we will be reworking components such as 0805 and 1210 size caps and resistors, along with SOT-23 and SC-70 size packages. We might eventually get into BGAs. This board will most likely be a double-sided board, probably
Electronics Forum | Thu Sep 07 15:24:29 EDT 2000 | Murad Kurwa
Steven, Try http://www.document-center.com/home. You will find various standards for BGAs freely-available but not for free. BTW, I have never seen a BGA underfilled. Only FC and CSPs. The standards available will explain when to.....High CTE delta
Electronics Forum | Wed Nov 07 21:36:17 EST 2012 | davef
Multiple process and rework thermal cycles are brutal on boards and components. Improving reliability of products through reducing thermal stress ends-up being a major driver to the interest in lower MP LF solders. Binary LF solders require the addit
Electronics Forum | Wed Apr 28 14:41:45 EDT 1999 | Bob Willis
| | What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? | | | | Thanks, | | | | Frank | | | Frank, | Refer to the device manufacturers. they are going t
Electronics Forum | Wed Dec 09 18:51:06 EST 2020 | johndep7
My company has been having issues with a lot of solder balls, solder splash, and flux balls all over a specific board. Now this is one of the only companies that require us not to clean our boards after our work is finished but this is also causing a
Electronics Forum | Fri Jul 23 13:34:07 EDT 1999 | Scott McKee
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Fri Jul 23 14:17:55 EDT 1999 | Steve Schrader
| | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performin
Electronics Forum | Tue Jan 20 09:41:25 EST 2015 | rgduval
Well put, Evtimov! :) I've made my argument against it. I'm not comfortable taking a job placing parts outside the capabilities of the machine in general, much less parts that I can't actually see! The machine is good down to .5mm pitch parts, and
Electronics Forum | Tue Jan 31 15:15:13 EST 2006 | russ
Heat guns used improperly will definitely damage components. You must have a controlled heat gun that can be set to the max temp you want pb =215C max, Pbfree maybe 240C max. This heat gun must not be able to be adjusted or you must have total trus