Electronics Forum | Sun Nov 04 19:13:25 EST 2018 | cirsol
Thanks. Have tried registering again and sent ASM an email. Since my original post I have been able to locate the user manual with schematics etc, but the documentation that I have is still quite lacking in terms of troubleshooting and defining machi
Electronics Forum | Sat Jan 10 15:19:28 EST 1998 | Jon
Check out the web site www.conceptronic.com I think you will see that the Conceptronic ovens are the best and most reliable over the long haul. Micron CMS has over thirty five of them and has stated that they were the most reliable and best vendo
Electronics Forum | Tue Mar 20 08:04:47 EDT 2018 | spoiltforchoice
Those of us doing low volume with mesh ovens and double sided boards will often use the titanium strips used for making boards more rigid for wave soldering. Gives you enough clearance for lower profile items that you would typically find on the firs
Electronics Forum | Fri Aug 03 21:08:40 EDT 2001 | Rob Fischer
Good question Dave. Kerry has participated quite a bit in this sort of forum but I have yet to hear whether he is a user or a critic. Check out the Apex exhibitors manual to see all of the vendors that are available or the archives on SMTnet. You
Electronics Forum | Tue Jun 01 17:05:50 EDT 2004 | ssmith579
Been there, done that. I'm looking for a users manual or something to show the different configurations or if different sized nozels are supported.
Electronics Forum | Fri Feb 25 14:29:27 EST 2005 | sasha
CSM 84 III have message 108: SPEC. DISAGREEMENT The User Manual have not these mistake. What is this? Thanks
Electronics Forum | Mon Feb 05 19:02:18 EST 2007 | gmarina
I'm looking for the Philips CSM 84 VZ user and service manuals, and if it's possible, some advice to start with this machine, it's till in the crating! I don't want to do damages or mistakes. Can anyone help me? Tanks Marina
Electronics Forum | Mon Sep 12 14:12:40 EDT 2005 | Jari
HI! Does anybody know driller/miller called "Direct Imaging System II"? I have one, but its not working properly. I think that there is some corruption in software. All kinds of information about this machine is welcome: manuals, software, other user
Electronics Forum | Mon Jan 16 09:18:08 EST 2006 | russ
We are using our SPM to .012" pitch with excellent results. It has the manual vision. (two cameras with user defined outlines used with mylar alignment) EDIT - I meant 16mil pitch, not 12!
Electronics Forum | Wed Jan 18 17:00:18 EST 2006 | gipos
Can someone help me with Hollis FCR310 reflow owen data. Seems that it is difficult to find anything.After Electrovert purchased Hollis, the support is missing. Where to find user/service manual.....? Any data will be highly appreciated. Thank you
