Electronics Forum | Sat Feb 22 11:37:00 EST 2020 | kylehunter
Hey all, I've made a post in the past about us expanding to a new space, but I wanted to do a new post with specific questions. We currently have a DEK 265, Phillips Opal Xii, and a Heller 1500. Our main reason for expanding is to have a lead-free
Electronics Forum | Fri Apr 05 18:22:18 EDT 2013 | Adam
We have two ZipaTec 460s Selective Solder Machines, one for Lead and one for Lead-Free. This morning we noticed the solder pot was covered in solder balls, and after asking the operator what they had run, the answer was "Nothing." The operator had al
Electronics Forum | Thu May 09 12:06:06 EDT 2013 | pbarton
We run Zipatec 460's also. I presume that you are running Nitrogen? We have found that if the Nitrogen flow rate is too high into the conical nozzle collar it can be sufficient to disrupt the smooth flow of the solder as it runs down the wettable o
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Mon Dec 10 13:26:40 EST 2012 | dyoungquist
We are using our selective solder machine to solder a backplane with sixteen (16) 4x48 pin 0.080" connectors. Our first pass yield is about 85% meaning that 85% of the connectors come out with no bridges. Not quite as fine pitch as your connector a
Electronics Forum | Mon Jul 17 11:40:20 EDT 2006 | Chunks
It's been a few years, but lack of preheat was my problem with this machine.
Electronics Forum | Tue Feb 26 14:39:19 EST 2013 | eniac
Hi, guys. Does anyone use a EBSO selective soldering machines? Can you write your parameters for two rows connector? Thx!
Electronics Forum | Thu Jul 13 13:51:13 EDT 2006 | George
I got some info about it last year. I could not justify ROI since this machine was way too expensive (same thing with Vitronics Selective machines). You need to see if this machine will increase your throughput or not depending on your products. Al
Electronics Forum | Fri Jun 29 12:47:25 EDT 2012 | deanm
We are experiencing widely varying First Pass Yields for selective soldering. Some boards are near 100% while others are less than 50% depending on the pitch and general complexity of the board. Question: If you are running 100 boards through your s
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav