Electronics Forum | Fri Jul 23 12:49:47 EDT 1999 | Tony
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Mon Jul 26 10:44:08 EDT 1999 | Boca
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Fri Jul 23 23:47:03 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Sat Jul 24 00:04:55 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Thu Sep 22 10:48:08 EDT 2005 | Rob
Cheers Greg, It's unusual to have such direct access to manufacturers & their opinions. I'll tell you what really does get us, and splicing doesn't work well on these occaisions - big SMD connectors, requiring deep pocket feeders. You only get m
Electronics Forum | Tue Aug 22 03:04:07 EDT 2006 | PP
Any help/suggestion is much appreciated I am doing lots of BGA Reworks from a small uBGA with a few balls to a large BGA with over 1500 balls. The reworks have been done on SRT 1100 Series Machine for many years. SRT 1100 Machine is good for the c
Electronics Forum | Thu May 22 16:52:39 EDT 2008 | tonyamenson
Indium got back to me with the attached PDF. I always assumed, that in order to avoid thermal shock, there could not be any more than 80 degrees C difference between the solder pot and the pre-heated board. However, it would seem that any thing le
Electronics Forum | Fri Jul 23 13:09:48 EDT 1999 | Steve
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Tue Jan 17 17:28:47 EST 2006 | adlsmt
I would agree that anyone buying a new machine should run boards on it. As well I agree with almost everything you said. We did run boards on a Mydata machine. If we were shorter runs and higher mix I would have bought one. We paid a local comapny a