Electronics Forum | Tue Mar 03 03:11:57 EST 2015 | vb7007
Hi I also forgot to mention, top side is reflowed first at SMT. Tenting vias is good option. we are looking into it. Can you please also suggest any solution to avoid solder balls at bottom side in other places than vias. Thanks
Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
Electronics Forum | Sun Nov 24 20:43:15 EST 2019 | sssamw
If you want to check if solder mask on tented via, better to do cross section to have a clear view. Sometime supplier will not tell you the truth once you ask question for potential quality issue.
Electronics Forum | Mon Feb 26 12:26:43 EST 2001 | CAM
I'm working a problem and looking for your input. Here the deal: Two sided mix technology board. Test is using unmasked via points on bottom for test points. Our fab drawing states tent via points on top side. First set of board came in with no tenti
Electronics Forum | Tue Feb 19 11:08:22 EST 2002 | Chris Anglin
Guideline for Tenting Interstitial BGA Vias It is difficult to give a complete recommendation on via tenting without an idea what process conditions are required (ex: wave pass, double reflow, rework etc.). Via Pads (as Test Points) - On Bottom
Electronics Forum | Fri Feb 22 14:22:07 EST 2008 | stevek
Are you using nocleans, especially when you get to SMT? Years ago, I had OA wave flux get into vias that were plugged from the top under parts. It is really difficult to clean small, high aspect ratio vias. Cross sections showed that the copper in
Electronics Forum | Tue Jun 03 14:28:49 EDT 2008 | cdsullivan
Good Afternoon, I know that most of the answers I get for this are going to be along the lines of "it's up to you" and I realize that. But, I was wondering what the most common type of profile that is used in your shop and why? Is it the older "S
Electronics Forum | Sat May 18 15:19:55 EDT 2013 | isd_jwendell
OK, I've now read all of the documents you referenced. The problem still remains regarding the thermal vias and how to minimize scavenging. All the docs acknowledge top and bottom tenting, and it's problems. TI says don't do it. Plugging is usually n
Electronics Forum | Wed Apr 26 10:59:54 EDT 2000 | Jose Baez
Sal: You are Correct running firts the reflow side then glue side. In my Experience I've seen a reverse procesess( first glue"cure" and then reflow side) but the quality results were not good, because We realized the Glue tent to cristalise and when
Electronics Forum | Mon Apr 16 12:31:27 EDT 2001 | mparker
If, after all the good advice already given, the engineer insists on following his wacky design, you may still be able to influence some success. First you have the fab house plug the via holes with solder then you make sure that the bottom side of