Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Tue Dec 01 14:44:04 EST 1998 | Terry Burnette
| Hi | I have been conducting my first reflow profiles. Most of the texts that I have read suggest soldering the thermocouples to a populated pcb. I am finding this very difficult. I have been using a high melting point (Sn5 / Pb95) solder and the
Electronics Forum | Mon Sep 27 16:52:48 EDT 2021 | aex
During production the temperatures on the last 3 zones are approx. 20F higher than the setpoint. The other zones are operating within spec. We checked power, I/O, SSR's, thermocouples, and exhaust, but the issue remains. We did not check resista
Electronics Forum | Thu Jan 09 11:29:41 EST 2014 | spoiltforchoice
Thermal profiling typically requires a profiling kit, this will include a thermally insulated datalogger that follows your PCB through the oven connected to a number of thermocouples which you might affix to your PCB using heat resistant tape or usin
Electronics Forum | Fri Mar 21 14:44:02 EST 2003 | Stephen
I once worked for a new branch of a company. We had a board where one of two tants would shift in the oven. When I phoned up HQ because they had ran the board before as soon as I said the product name their guy said "C148 shifts in the oven" He knew
Electronics Forum | Tue Jan 31 17:18:37 EST 2017 | mainenetservices
You can contact Heller service by email info@hellerindustries.com to get help with any issue. High Deviation or high process alarm could be due to one of the below reason. A. Blower motor in subject zone is not running – check for air flow B. Heat
Electronics Forum | Mon Jun 25 20:39:08 EDT 2001 | ianchan
Hi mate, no complete info given from what i see, so just some humble comments, mayhaps you review : 1) PCB pad finishing - Copper+nickle plated? coz if so, nickle is a KILLER to good solder wetting. what we did back here, was to HAL coat the nickle
Electronics Forum | Sat Feb 27 20:02:06 EST 2010 | jmelson
Yup, that seems to be the procedure in the manual. But, it gets complicated, as the head has a rotation, the part has a rotation, and the MA station has a rotation, and it gets pretty confusing to figure out which way to tweak the offset values for
Electronics Forum | Fri Oct 08 10:08:48 EDT 1999 | Glenn Robertson
| | | | I have a board, 4 spacers needed to be soldered on the board | | | | first with the normal 62Sn37Pb alloy. Then, capacitors are manually soldered on the boards. The density of the board is quite high. If we wave soldered capacitors first,
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in