Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue Feb 18 16:13:04 EST 2020 | bk
Just by looking at your attachment and seeing that error, I would say that you didn't put in the magic word when you reloaded your software or mistyped it if you did. If you don't have your magic word you will need to contact mydata or whoever you bo
Electronics Forum | Sun May 07 16:55:27 EDT 2023 | rw
There are times where even if you have the tools on the hydra, they are assigned to the package, and the hydra is active, the machines algorithms will determine if the single mount is faster or easier depending on density of the design. Parameters
Electronics Forum | Mon Apr 30 09:55:50 EDT 2007 | rgduval
We're running an older TP9-U, and clocking in somewhere around 3000 cph, realistically. Placements, however, are very accurate. Works fine down to 0402's, high-pin count QFPs, etc. My -U doesn't do great on optical centering...it works, but it's a
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
Electronics Forum | Fri Jun 03 11:13:28 EDT 2011 | jeremymc
I've been running a MYDATA TP11 for over a year now and yesterday when I turned it on I was given an error that I have never seen before. It had been a week since the last time I had used the machine and when it was turned on it told me that there
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Thu Jan 06 12:41:37 EST 2011 | bk
That depends on what service screen you are using there are 2 of them.One is the exit to service under your exit prompt. The other is an extended version of the service program and you have to exit tpsys under the exit prompt and type in service -x w
.gif)
