Electronics Forum: trays (Page 7 of 75)

Matrix Trays

Electronics Forum | Wed Oct 16 20:24:45 EDT 2002 | kenbliss

Hi ChrisN Have you talked with your supplier that is sending the components into your plant in trays. They are putting the components into the trays or their source is. One of them should be able to give you credit for each returned tray. Ken Bli

FUJI IP1

Electronics Forum | Thu Dec 16 17:11:51 EST 2004 | jdengler

Clayton On the tray tower, the tray that's at the pick-up level flags a sensor at the back of the tray right next to the lead screw. This sensor needs to be made to zero the machine. Either the trays are out of position or the sensor is bad. Jerr

OPAL XII tray feeder

Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh

REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.

Using Stripfeeders on MyData Tray Wagons

Electronics Forum | Tue Jun 24 14:00:58 EDT 2014 | joekirin

We built a tray that accepts tape. It is made out of a waffle tray and board breakaways. It works very well. We use magnets to mount it on our Y-Wagon teaching it as a tray.

Matrix Tray Holder

Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester

Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co

Universal GSM Tray Feeder

Electronics Forum | Wed Jan 19 11:08:16 EST 2000 | Steve

Hello All, I am evaluating placement m/c's and I have looked at the Universal Flexjet. However we will be using both taped components and components from tray. The tray loader Universal use is much cheaper that their PTIF shuttle system, however I a

Universal GSM Tray Feeder

Electronics Forum | Wed Jan 19 11:02:26 EST 2000 | Steve

Hello All, I am evaluating placement m/c's and I have looked at the Universal Flexjet. However we will be using both taped components and components from tray. The tray loader Universal use is much cheaper that their PTIF shuttle system, however I a

Matrix Trays

Electronics Forum | Tue Oct 15 13:53:15 EDT 2002 | cnoonan

I am looking for companies that buy used Matrix trays in excellent shape. I have over 5000 trays per month and I am looking to sell them to customers that need trays. We have several types of trays for QFP�s, BGA�s and several other miscellaneous t

Matrix Tray

Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax

"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest

Matrix Tray Setup

Electronics Forum | Wed Dec 30 15:05:18 EST 2009 | bobpan

Craig: Make sure you have done a table changeover and then when you go into teach tabletop there should be a tab at the top that says matrix trays. After selecting that ...choose the tray you want below and then right click on a part on the tray in t


trays searches for Companies, Equipment, Machines, Suppliers & Information