Electronics Forum | Thu Apr 23 07:51:45 EDT 2009 | scottp
Every paper I've seen published shows that BGA voids either have no effect or actually give a slight improvement. The one exception are voids with a root cause in bad incoming boards, such as champagne voiding where nearly the entire interface is go
Electronics Forum | Wed May 19 17:43:25 EDT 2010 | pforister
Hello, I'm having problems with voiding on an assembly that has a GPS hybrid with balls much like a BGA. This is a RoHS assembly using no-clean solder (Kester EM907). The voids are at or above 25%. I use an 8 zone oven where I peak in zone 7 and
Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Mon Dec 22 16:02:22 EST 1997 | Justin Medernach
| what is your experience about the presence of the voids in the joints ? | Are they dangerous and when ? Vincenzo, Voids in solder joints can be caused by a number of factors. Let's begin with the flux vehicle in your soldering media. If the prope
Electronics Forum | Mon Sep 11 20:30:21 EDT 2000 | Dave F
Don�t kid yourself Sal, either: * Components were always falling off your board, but someone just noticed it ... OR * Something in your process HAS changed ... OR * Both Voids are primarily process indicators. I won't comment on the cause of the
Electronics Forum | Mon Jan 17 13:09:12 EST 2000 | Dennis _F
We seem to have voids show up in one out of 5 BGAs during x-ray inspection. The x-ray is set up to accept the joint with anything less then 30% void area. I need anyones input of what during the process we can do to decrease the voiding and/or a good
Electronics Forum | Wed Mar 15 08:47:50 EDT 2017 | emeto
From what I know, you should follow IPC standard for the class assembly that you are building. From your post somebody mentioned something somewhere - doesn't make it official information. I would not be worried about having voids, but what is their
Electronics Forum | Tue Apr 13 09:46:39 EDT 2004 | davef
Now, that's different. We misunderstood the problem from your original descrtiption. We thought the voids were showing at the via in the pad. Now, we understand the voids appear to be in the solder balls. Suggestions are: * Search the SMTnet Arch
Electronics Forum | Mon Mar 15 15:52:38 EST 1999 | Earl Moon
| After switching from No-clean flux to Water soluble (Kester)we encountered voids problem (X-ray and microsectioning). Reducing the apperture sizes made the voids smaller but did not eliminate them. So we had to go back to No-clean. Any idea why voi
Electronics Forum | Sat Dec 20 14:06:58 EST 1997 | Vincenzo Longobardo
what is your experience about the presence of the voids in the joints ? Are they dangerous and when ?
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800