Electronics Forum | Sun Feb 28 20:05:54 EST 2010 | aungthura
Dear all There are alot sockets in our products,BIB.These skts are lifted abit after being solderd with wave machine.If the skts become lifted, how much tolerance of the high is acceptable? as example 1mil~5mil,or,1mil~8mil. Pls advise me. Thanks in
Electronics Forum | Mon Sep 10 12:27:32 EDT 2007 | hakerem
Hi Dave - You are correct that I was not clear in my comments. I assumed Joris had seen the usual solder balls accompanying his blowholes. Nevertheless, Joris, my first two recommendations still stand. Increasing the dwell time of your leads in t
Electronics Forum | Mon May 19 10:35:58 EDT 2008 | samir
I agree with RealChunks. The application of any of these "wave solder process control tools" is dependant on how the shop is run. At some shops, PM is inconsistent and slacked off on. At other shops, there is no technical expertise at the operator
Electronics Forum | Wed Nov 20 07:50:00 EST 2002 | aerineng
Hi, I'm an SMT refugee working in component manufacture - hey, times are hard! I've been asked by a customer to test some of my parts at high temperature on the wave - up to 360 deg Celsius. I've checked my wave and it's only capable of getting up
Electronics Forum | Sat Feb 15 15:39:53 EST 2003 | Joe
I have the identical machine and setup as you with the same issue(s). I looked at setting up for N2 but am choosing to retrofit to a standard lambda nozzle setup. If you are soldering bottom side SMT parts or other challenging assemblies, N2 may ma
Electronics Forum | Thu Jan 15 12:31:06 EST 2009 | wavemasterlarry
Well I finally got the power turned back on at my house. Guess they only let ya slide so long without paying the bill. I still say 4 months is OK - especially inthe winter time. But requardless, wave soldering 0402s is nuts. Getting adhsive to fi
Electronics Forum | Fri Dec 01 08:09:08 EST 2006 | CK the Flip
Square-leaded pin headers will typically bridge at the trailing edge (last couple of leads), since during peel-back, the solder at the trailing edge has "nowhere to go". If you have control over designs, ask your designers if they can put solder thi
Electronics Forum | Fri Feb 21 10:31:48 EST 2003 | adlsmt
We dont have the debridging knife. I had one on an old Hollis machine I had once. It was totally worthless. I am setting up the nitrogen today. I will let you know how its goes. We are using a water based no-clean. The nitrogen will probably make a
Electronics Forum | Wed May 12 07:34:42 EDT 2004 | RLeonard
The standard machine is set from the factory at 7-9 degrees, 7 is the most standard, why are you considering the change? before doing any thing to the machine, first identify why? what type of defects are you seeing? I have found, depending on the t
Electronics Forum | Mon Dec 04 20:11:45 EST 2006 | billwestiet
Lots of answers, but none to the question you asked. I don't know of any ppm standards, none would be a good place to start. If you have a particular re-occuring problem with a specific connector or location, e-mail me. bill@ietechnology.net Is t